How to Replace Front Outer Tie Rod 2007-2013 Mitsubishi Outlander

Buy Now!
New Tie Rod from 1AAuto.com 1aau.to/ia/1ASTE00686
This video shows you how to install new TRQ outer tie rods on your 2007-2013 Mitsubishi Outlander. Outer tie rods, sometimes referred to as “tie rod ends,” connect the steering rack to the steering knuckle. Their joints can wear out over time, causing loose steering, vibrations, and uneven tire wear. They are also a common failure point in localities with safety inspections.
This process should be similar on the following vehicles:
2007 Mitsubishi Outlander
2008 Mitsubishi Outlander
2009 Mitsubishi Outlander
2010 Mitsubishi Outlander
2011 Mitsubishi Outlander
2012 Mitsubishi Outlander
2013 Mitsubishi Outlander
Tools you will need:
• 13mm Wrench 1aau.to/oIq/1AXAA00010
• 19mm Wrench 1aau.to/oIq/1AXAA00010
• 22mm Wrench
• 17mm Socket 1aau.to/oaVc/1AXAA00015
• 19mm Socket 1aau.to/oW8/1AXAA00043
• Ratchet 1aau.to/oa9N/1AXAA00016
• Socket Extensions 1aau.to/oaVc/1AXAA00015
• Torque Wrench 1aau.to/oafX/1AXAA00044
• Marker / Writing Utensil
• Hammer 1aau.to/oIZ/1AXAA00091
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@user-pc7tt1iz8m]

good video with one exception...it's pointless counting the rotations...you disregarded it anyway. But thanks for a good video anyway. Very helpful.

[@edg3932]

Good video, but putting the bolts back on during the tire installation wasn't good . You should have put the tire bolts on by hand for a few threads to prevent cross threading and then use D your drill To continue tightening.

[@foxman-56]

u never showed loosening the lock nut, to start with. So when u put on the new tie rod - ur lock nut was already lose - and you said' tighten up the lock nut'.