√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money
@castajc8210 ай бұрын
You don’t have to remove the ball joint. 10 year Honda tech here. We get those done in 30 minutes. Just unbolt axle nut and losses axle from knuckle. U can move The whole knuckle out giving u plant of room. Just use a large prt bar so remove control arm from sub frame
@416diy Жыл бұрын
I've done this job, it sucks. I don't care for that corny edit you did at the ball joint removal. That ball joint is very stuck in the knuckle, and there are 2 ways to get it out, 1 - pickle fork and ruin the boot, or 2 - separate the strut and axle from the hub and use a tie rod or ball joint separator to get the ball joint out. If someone watches this and thinks they can do the same as in the video, they may not have the tools to finish the job.
@src44099 ай бұрын
We always turn the ball joint so the hole in the stud runs front to back. That way you can get your cotter pin in and out easily and bend it.
@eldoradony Жыл бұрын
Can this bushing job be done without removing the ball joint? The video clearly shows a new arm being re-installed.
@Henry-lw6yw Жыл бұрын
Do you know how to replace that bushing for the newer models?
@ericboisselle1145Ай бұрын
thank you so much your videos are some of the best out there
@jacobchung19703 ай бұрын
Rename the video, it’s “rear” not front control arm