How to Replace Front Brakes 2015-2019 Hyundai Sonata

Buy Now!
New Brake Pad & Rotor Kit from 1AAuto.com 1aau.to/ia/1ABF...
This video shows you how to install front brake pads and rotors on your 2015-2019 Hyundai Sonata. Brake pads wear out over time, much like tires, and need replacing, on average, every 50,000 miles, with variations depending on driving habits and environment. Brake rotors may also need to be replaced if they are warped or grooved. Often, it’s safer and more cost effective to replace pads and rotors at the same time. Squealing or grinding noises, or wheel vibration are all symptoms of worn brakes.
This process should be similar on the following vehicles:
2015 Hyundai Sonata
2016 Hyundai Sonata
2017 Hyundai Sonata
2018 Hyundai Sonata
2019 Hyundai Sonata
Tools you will need:
• Pry Bar 1aau.to/oJe/1AX...
• 10mm Wrench 1aau.to/oLS/1AX...
• 17mm Wrench 1aau.to/oLS/1AX...
• 10mm Socket 1aau.to/oaMY/1A...
• 14mm Socket 1aau.to/oa5j/1A...
• 17mm Socket 1aau.to/oa5j/1A...
• 21mm Socket 1aau.to/o3e/1AX...
• Brake Caliper Compressor Tool. Dual Piston. Pump Style. 1aau.to/o4/1AXA...
• Brake Caliper Compressor Tool. Quad Piston. Ratchet Style. 1aau.to/oag/1AX...
• Brake Caliper Compressor Tool. Single Piston. Lever Style. 1aau.to/oaz/1AX...
• Brake Caliper Compressor Tool. Single Piston. Screw Style. 1aau.to/oE/1AXA...
• Brake Caliper Hanger 1aau.to/ogM/1AX...
• 1/2 Inch Breaker Bar 1aau.to/opV/1AX...
• 3/8 Inch Breaker Bar
• Ratchet 1aau.to/obgC/1A...
• Torque Wrench 1aau.to/oanh/1A...
• Brake Grease
• Brake Parts Cleaner
• Copper Anti-Seize
• Gloves 1aau.to/oAB/1AX...
• Paper Towels 1aau.to/oxn/1AX...
• Safety Glasses 1aau.to/ouw/1AX...
• Surface Prep Discs 1aau.to/ok/1AXS...
• Drain Pan 1aau.to/oty/1AX...
• Floor Jack 1aau.to/oQG/1AX...
• Jack Stands 1aau.to/oLE/1AX...
• Rubber Mallet 1aau.to/ofm/1AX...
• Wheel Chocks
• Wire Brush 1aau.to/op4/1AX...
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@tlynn609]

This was by far the best video & most detailed video I've seen on KZbin explaining how to change brakes!! Thank you!!! Edit: I'm female & went off your list of tools & everything needed to get the job done & I changed my front & back brakes & rotors for first time in my life with no problem. Only thing that ended up being a little bit of a struggle was not being strong enough to get some bolts unscrewed so I just wd40 them & waited a few & piece of cake. I was quoted $800 for front/back brakes/rotors (i swear cuz im female mechanics try to take advantage of that). It ended up costing me $285 for parts & a little less than $100 for tools so now in future all I need is parts. $385 compared to $800 which is like $200 each brake/rotor & I coulda got shit brands but I got one of the top of the line brake sets. Thanks again for the detailed instructions!!

[@peterfrey1853]

I like how the tire went back on with the old dirty rotor in place… The torque specs were a nice touch! Thank you.

[@tonyman2c]

I think very few shop will be willing to spend the time cleaning and lubricating the caliber pins like you did. That's why I wish I could change my own brakes. 😂

[@Bryangarcia-go5un]

Wouldn't cleaning the rubber with the brake cleaner cause the rubber to deteriorate faster over time?

[@jamesspalding3981]

Cam I use a big C clamp to push caliper back

[@yourfactstory]

Thanks my friend but why you have back the old rotor at the end ?? ...Subscribed !

[@jmrandom194]

Good video, but NEVER put antiseize on your wheel studs. That will result in pressure against the threads well beyond specs when you torque the lugs. That's why it's best to use antiseize from a jar with an applicator brush vs aerosol. Otherwise good/detailed video.

[@jackbuehler9478]

Why you have the old rotor on when you're putting the tire on

[@Brooklyn1530]

6:00 I heard that laugh lmao.....hit it from the back....giggity

[@dontdoxmebro]

Why didn't you install the brake pad clips?

[@bcchristopher688]

No grease where the pads slide in the hardware or where the caliper hits the pads?

[@johnrogers5264]

Where did the new rotor go? Curious 🧐

[@javiergonzalez6920]

Question: Is it a bad idea to open the brake fluid can lid to compress the calipers at installation time instead open the caliper drain plug?

[@jeffcon123]

I’m fixing to do mine, rotors are still in shape so.. I just needed ro double check the process I plan to clean it all and make sure it works great

[@gustavorangel2533]

The disc rusted while I was checking the brake league hahaha

[@crazyloco8844]

Excellent job!!! Love the way you explained everything. Thank you.👍💪

[@hoosiermad8753]

Would this work on a 2021 hyndai sonota?

[@juanarevalo686]

No brake pad clips?

[@cleewert]

Nice work, it helped a lot, major components needed to this is patience and being handy with tools otherwise I suggest you go to a shop! Brakes are a difference maker,,,, You need to be able to stop!!!!!!

[@gregsexton6544]

Was there someone holding the pedal down after you pumped your brakes for bleeding the air. Not real clear how you did that? Like the video.

[@jeremywolfe6916]

I’m replacing the rear brakes and I don’t remember if the caliper bolt with the black rubber piece on it , goes on the top or bottom of caliper

[@DeadCelt]

I think your lug nuts were over torqued. Bad thing about using the drill to initially tighten them

[@rareairentertainment2794]

Wow what a great video

[@adamcoss7533]

Does anyone know where to buy the spray on antisieze?

[@DeadCelt]

Where does this person live to have so much dang rust?

[@one2omg154]

Outstanding and thorough. Thank you!

[@Roxanne_Lipz]

How much does that cost ?

[@edwardsarah957]

You're an OCD Maniac. I Love it!!

[@CalkoLouie]

Great Video well done

[@MrSilvervw]

Fantastic content 👌 👏 👍

[@raultellez7497]

Very. Helpful. Thank you.

[@MrSmokenpurp]

Ah that’s why my breaks are still squeaking I put the squeaky indicator on the outside 😅 time to flip them over

[@DaddyChriis]

Love the work!!!

[@LoveWins]

Those are some crusty calipers for only being a 2015

[@williamcollins4545]

Man I’m glad I don’t live in the rust belt

[@cbnx82703]

Pry Bar ? How about a 1/2” Drive Breaker Bar instead…!

[@corygraves6480]

Who ever this car belongs to must don't drive it the rotors are rusty

[@bigotonbrand]

18:35 70ft lbs