TSPROF Ultra. Convex Attachment

[@TSPROFSharpening]

Learn more about TSPROF Ultra: tsprof.us/collections/new-products/products/tsprof-ultra-convex-attachment-6-mm

[@nenadstokic2558]

Perfect engineering! Best regards from Serbia!

[@ActiveAtom]

Hi Serbia, we agree with you even here in the high desert Joshua Tree National Park California USA.

[@TSPROFSharpening]

Thank you! Nice to know we're watched in Serbia either!

[@TSPROFSharpening]

Warm regards!

[@95993harpo]

Why do you say horizontal position for Blitz and vertical for Kadet?

[@dobarcvservis535]

After finishing the sharpening process and debur with last stone (let us say last diamond stone is F1500) how should I strop with leather or balsa strop with paste? Should I strop with higher grit pasta with convex adapter or without it?

[@TSPROFSharpening]

If you want to strop a standard V-shaped edge you'll not need the convex adapter. Simply increase the angle by 0.2/0.3 degrees and use paste of the same gritness or higher.

[@GrizzlyPanda347]

@@TSPROFSharpening but stropping a convex edge after stone progression with the convex attachment is recommended?

[@cfishel15]

This looks very good! Will it work with the K03 sharpener?

[@TSPROFSharpening]

No, but we're gonna release for K03 quite soon.

[@simonbaptiste344]

Where can I get one ?

[@TSPROFSharpening]

tsprof.us/collections/new-products/products/tsprof-ultra-convex-attachment-6-mm It's in stock in the end of July

[@StariyLemur]

😂

[@Riyame]

Seems odd and over complicated that you need to have one hole for straight sharpening then need to move it 90° to do convex sharpening. The Hapstone gen 2 convexing attachment can go from straight to convexing with a thumb screw and adjusting the angle, no need to move the guide rod location.

[@TSPROFSharpening]

This solution was chosen to provide a wider range of sharpening angles.