The flight time is more than 20 minutes with battery of 12S/32Ah. However, Turnigy dlux 250A HV only bench test.
@mayamikan11 жыл бұрын
hi Tony Turnigy dlux 250A is good in the case of radio control because it is cheap. jeti300 can rest assured that if a person is flying.
@HOVERSURFOFFICIAL9 жыл бұрын
you are amesome!
@mayamikan11 жыл бұрын
私はこのバッテリーを合計9本買いました。 I bought a total of nine batteries. 最初8本購入、4回使って1本が壊れたので、後から1本を買いました。 I bought eight batteries at first. But I bought another one because it was broken one using four. 壊れたバッテリーは最初から1Sがアンバランス(0.08V低い)でした。 1s of broken battery was 0.08V lower than from usual. その後20回程フライトしているが今の所問題はない。 I have a flight about 20 times, but then there is no problem. ZIPPY Flightmax 8000mAh よりnanotechの方が、軽くて、小さくて、パワーがあります。 nanotech is light than ZIPPY Flightmax 8000mAh, small, and high power.
@JDspeedandFab.11 жыл бұрын
HELLO,THANK YOU FOR YOUR TEST VID, SO IS THIS ESC STILL GOING STRONG? THANKS AGAIN.
@Leo83bmx11 жыл бұрын
Hi! Nice video! I have a question. Which one of these engines is better in terms of power and robustness? CA120-70 or RotoMax 150 cc? Thanks!
@ChrisGermano9 жыл бұрын
What button combination did you use to enable the programming box to work with this ESC? I have the same setup here and it wont move past the Hextronik screen.
@tigertiki120011 жыл бұрын
Hi Mayamikan, How are the 8000 mah nanotech batteries perform ? I'm about to buy 6 .. Thanks
@2447582111 жыл бұрын
hi mayamikan how would you compare this ESC against the jeti300 which is more reliable
@2leoybrv11 жыл бұрын
for use in paramotor recommends jeti300?
@2leoybrv11 жыл бұрын
How many minutes do the batteries last?
@2leoybrv10 жыл бұрын
is possible to have 10 minutes of runtime with 4 batteries Turnigy nano-tech 8000mAh 6S?
@mayamikan10 жыл бұрын
Flight time would be 7-8 minutes it's weight 70Kg battery of 12S/16Ah. (without updraft)
@kuupkoo56310 жыл бұрын
Hi, are you still there? I am interested in electric paramotor an i want to ask how you control the ESC? I can see a throttle unit which you are using(thing you are pushing and the motor is rotating / the thing which you push in and the motor starts rotating). From where i can get this thing and how to connect it to the ESC or there are other possibilities to control the speed of rotating? Thanks
@mayamikan10 жыл бұрын
My setting of SPIN BOX Please look at 3 min 45 sec of this video. Variable resistance of servo tester set at tip of the throttle wire.