Twin Cam Harley FXR AFR Gauge Test Ride and Timing Tuning

[@Junior-fd8ux]

Watching this relaxing and started to doze off until I heard that first pull and it woke me right up and even gave me a little tingle lol. Cleanest blue frame iv seen besides FXR Robs, both beautiful built bikes. Btw like the air cleaner paint job. I was thinking of trying that on a S&S teardrop cover.

[@EngineersGarage1]

Haha lots of hard pulls in this video to get the tuning right. Thanks man! wanted to do something a little different to break up the chrome. I think I would look great on a teardrop. I lightly sandblasted the chrome to give the paint a good surface to adhere to.

[@twinsmotogarage1866]

Somewhat like a dyno tune but on the street? That bike is so clean! Keep up the vids, almost at 1k!

[@EngineersGarage1]

Basically what I'm attempting. Keeping that air to fuel where it needs to be under wide open throttle. I'm spoiled when I tune my cars, data logging and a passenger seat of the laptop lol. Thanks my man!

[@sergiosanchez8510]

By far one of the cleanest Fxrs man I hope mine is as clean or close to being as clean as yours hope to see more content soon

[@EngineersGarage1]

Thanks brother! Yours is already looking clean, killer paint.

[@turbopete7794]

That bike is rad! Love the blue and chrome. I’d have kept it an evo though but that is just me.

[@michaelmitchell5909]

My 95" in my road king has some slight valve training noise....Tatro Machine told me any time you hot rod a motor there's gonna be a little noise....especially woth adjustable push rods...the bike sound amazing dude. Looks awesome too...

[@D_ambro0618]

Proud of you!! This video is great, as is your bike!!

[@sarsouelle]

Gorgeous bike !

[@austin2466]

Any more fxr content coming?

[@michaelmitchell5909]

Bike looks absolutely amazing. What cam you use?. New sub here man, i freakin love that bike...

[@EngineersGarage1]

Cam is Feuling reaper 543s

[@jimmyrustles8118]

Nice vid mate, the bike is so clean. Where did you end up with settings on the Twintec? Ive just gone with suggested settings as a base for the 95 im building atm.

[@EngineersGarage1]

Thank you brother! I'm at an initial timing of 4 and advance curve of 5. Seems like all my knock is gone now. After I burn through this tank of fuel I'm going to up the advance curve. I hate leaving power on the table.

[@weldermike7017]

Sounds strong man and looks dynamite!

[@LOGFAN87]

Bike is super clean man!

[@xc8487]

Also, what is your oil temp averaging? If it gets higher than 210 you should think about doing a below regulator oil cooler.

[@garryhorton9105]

Nice bike mate I was wondering what compression your at in relation to your module settings cheers 👍🏼

[@EngineersGarage1]

I'm at an initial timing of 4 and advance curve of 5. The engine is 11:1 compression ratio. I don't think my settings are optimal, but they're safe for now. Hoping to get the bike on a dyno this year

[@Boost5.0stang]

Kinda sounded like the clutch was slipping at high rpms. Sweet bike man.

[@hizacaine]

Looks like it too

[@BAsed_AFro]

What kind of money would a conversion like this cost typically?