I drilled a hole through the assembly tapped the gear change rod countersunk the handlebar used a countersunk bolt and slid my rubber back over works a treat
@thomasevans17286 ай бұрын
Hans seems to be a bit of a slacker 😅
@anthonypickering53716 ай бұрын
Watching you tug those grips on and the expressions you were pulling, you appeared to be very experienced at it 😅
@kevinhendon6 ай бұрын
Great progress Rob, glad you saved the Rubbers mate👍. Getting there 👏
@paulbarber19606 ай бұрын
Time with your wife 😮 Why have the garage and the toys 😉
@kickbackgarage6 ай бұрын
🤣
@alanterrar88626 ай бұрын
Its progress and that counts. Gawd knows what you said at the end about the exhaust, recon my PC sound was screwed.
@anthonyavorio70296 ай бұрын
It's a little late mentioning this now but there is always another scooter project around the corner to try it on...
@anthonyavorio70296 ай бұрын
A tip when applying grips...use hairspray...you don't need to heat the grips and it won't distort the grips when applying....the hairspray will allow the grips to slip on very easily and will dry keeping the grips in place and will prevent them from twisting prematurely...
@kickbackgarage6 ай бұрын
Brake cleaner fors the same trick as hairspray too. Just not on rock hard 63 year old grips
@anthonyavorio70296 ай бұрын
@kickbackgarage The only issue with brake cleaner is that it breaks down the plastic.. Great cleaner never actually dries where hairspray does. ,, Hairspray is not harmful to the Material grips are made from..
@61philpe6 ай бұрын
Got CASA rubbers for my GP but they seem to fit like a sock on a chickens leg. Tried hairspray & PVA. Every time I take panels off the rubbers come with them. Any thoughts? Keep the videos coming. Luv em
@iancarrington19676 ай бұрын
Have you seen the fork taper bearings from MB and Casa? Look interesting.
@kickbackgarage6 ай бұрын
Yes . Taper bearings work best when installed both up and down. So a combination of both should week great. Unfortunately the upper bearing from casa is non Chrome ring only
@solesust6 ай бұрын
Hey Rob would you recommend welding the gear change Rod while the handlebar is on the scoot?
@kickbackgarage6 ай бұрын
Just remember to take the earths to cdi and stator so you dont cook them!