You are so right about those instructions. They are just horrible. You would think they could hire one English speaker to at least edit the damn things.
@abdellahzaidi12572 жыл бұрын
Merci dennis pour cette belle video. il ya un au poste de coupure plasma qui porte presque le meme nom. CT 312. Je crois que tu connais deja. Il na pas l’afficheur digitale sur le pannaux avant. C’est quoi ton avis. En vers ce modelle. On disent qu’il est bon.
@diogomarques96633 жыл бұрын
Hey bro! I'm undecided if i buy a machine with the plasma cutter, do you gave him use? Do you think it's better than a grinding wheel?
@idennis753 жыл бұрын
It is quicker than using the angle grinder it takes a little bit of practice to get it just right but once you get it right it it's a lot quicker you still need the angle grinder to clean up the edges a little bit but it's not bad I actually like it
@idennis753 жыл бұрын
I don't use it much but when I do use it it works out pretty good
@victormanuelsorianosantana98063 жыл бұрын
una preegunta,para cortar con cut,la masava en el negativo u positibo
@idennis753 жыл бұрын
El positivo es con el que se corta, y el negativo es el que se atenaza a al material.
@abdellahzaidi12572 жыл бұрын
En positif bien sur. Torche de coupure sur le plus. Mass terre sur le moin.
@beccam10073 жыл бұрын
where is the fitting that goes on the argon regulator? there isn't one in our box?
@idennis753 жыл бұрын
Did not have a fitting to connect on the Oregon regulator
@beccam10073 жыл бұрын
@@idennis75 thank you. sending it back any way. has an internal air leak
@idennis753 жыл бұрын
That's the only reason I got the insurance on this one lots of people complain about issues