Upgrading the Proxxon Thermocut

[@moemilkshakes7532]

What I think the proxxon needs is a taller arm.

[@kyleclavette9445]

I am currently exploring a solution to this. I want the arm to be 3 inches higher

[@sadville13]

The one thing I want to make is a taller arm.

[@svengro5019]

Seems overly complicated to me. I just made an MDF jig that uses the original groove and is much more rigid.

[@hexedcrafting4621]

Oh, that is a certainly simpler setup, but I don't have the tools needed to make anything out of MDF so I went with this since it was all available pre-cut.

[@jacklalaing169]

Don't mean to sound critical but takes to long in the intro. Just list the arts and get on with it. You can describe them later as you use them.

[@davesykes1966]

...or just hold it with your free left hand...

[@pergatory_a]

Lacking a reason why I care at start