Mini CNC Lathe Retrofit Part 4 - Controller Housing, E-stop and Ladder Programming

[@joecnc3341]

Thank You - Very Much - for this YT Video series, your website and your insight. I have done a very similar thing with a DynaMyte 3000 Benchtop Lathe with rotating tool turret - but with Gecko driver, and Mach3

[@dennisbuns]

I enjoyed every part, please keep up the good work ! I've had limited experience with CNCs and hopefully I can save enough money to get one!

[@uptimefab7412]

Thank you for the compliments, much appreciated! Expensive hobby indeed, but very rewarding.

[@dichoseadepaso]

amazing project! tip: using cup saws in reverse leaves a much better finish in plastic. Just high speed and a steady hand and the hole will be perfect, no burrs or sharp edges. i use this for cutting holes in those Blue plastic barrels and big ABS storage boxes. keep it up!

[@uptimefab7412]

Thank you!

[@bobweiram6321]

Although you may not be able to find the safety door part, you can always make one by heating and bending a sheet of polycarbonate. You can always wet sand the pant to clean it up and use clear coat.

[@uptimefab7412]

Thanks for the tips! I hope I will never have to bend a new door, but that would would also be a nice skill to learn.

[@Festivejelly]

Very interesting... why not go for a small GRBL CNC controller though? This huge box seems a bit overkill.

[@uptimefab7412]

Thanks for the feedback, a GRBL would probably work just fine. I prefer a standalone controller, since I don't want to have it connected to a laptop during use. I like that it has its own screen and keys which are better protected against dust than a laptop. It is all personal preference though, (at least for a hobby machine) if you like the GRBL approach better, that should also work fine for a simple router.

[@MJPilote]

Pineline cleaner is very good for cleaning powder coated Emco. I use it on my emcos and it leaves it flat as intended.

[@uptimefab7412]

Thanks, looks like a good solution. Unfortunately not available where I live, but I am sure there is something available comparable to the Pineline brand.

[@maxcox6019]

Do you happen to know or have the wiring for using the winnc from the pc to the machine?

[@uptimefab7412]

Hi, I did not receive the Emco WinNC software with the machine when I bought it, so unfortunately I have no experience with the program nor the wiring.

[@thinkclear5292]

@UptimeFab one question - did you find the SZGH PLC manual is correct on their M-codes and descriptions? Working with a SZGH CNC1000 currently, and it is a bit of a mess...

[@uptimefab7412]

Hi, I have not gone though the PLC M-codes used in the controller beyond what was discussed in the video, so I am not sure if the codes in the PLC manual actually correspond to the ones used in the controller. I probably can't be of much help here. If you would like me to check something specific though, I can try to help.

[@DPTech_workroom]

👍