Using Paper Joins for Turning Bowls

Join the WWGOA community to access a huge library of woodworking instructional videos: bit.ly/38h8RoK.
Turning bowls on a wood lathe is an absolute blast, and if you haven’t tried it, you are missing out big time! Once you experience the beauty and satisfaction of bowl turning, you’ll be hooked. Like anything new that you try in the shop, however, there is a learning curve associated with turning bowls. One of the first things that you’ll need to learn is how to get the bowl blank mounted properly on the lathe so that you can work efficiently and safely through your turning project. It’s not difficult, but it needs to be done properly.
Once you have spent some time in your new hobby, you will likely want to add a four-jaw chuck to your arsenal, as one of the advantages that this brings is the ability to quickly mount the blank onto your lathe. Many beginning wood turners do not buy a four-jaw chuck immediately, however, and instead work with the standard-issue face plate that comes with most lathes. You don’t want to just screw the face plate directly to the bowl blank, however, because the screws will likely penetrate through the bottom of your bowl, which will cause you to turn a strainer rather than a bowl. Is there an inexpensive solution, you ask?
Become a WWGOA member today for instant access to hundreds of woodworking videos: bit.ly/38h8RoK.
Create a paper joint
A paper joint is a temporary joint that attaches a sacrificial base to the bowl so that the screws will not penetrate into the bowl. The joint will hold the blank securely while you turn your project, and the temporary base is easily removed when the turning is complete.
Let it cure overnight
Because of the high force that will be placed on the paper joint from the spinning lathe and cutting pressure, be sure to allow the paper joint to cure overnight before using it.
Looking for more woodworking instruction? Check out WWGOA premium membership! bit.ly/38h8RoK
🔨 Learn more on the WWGOA website: www.wwgoa.com

[@jordanbauman3828]

Thanks so much for this tip! I was skeptical, but it was perfect on the lathe and no screw holes in the bowl!

[@mhaz49]

I use this for inside-out turnings all the time. Will have to try it on bowls.

[@petervines9206]

Thank you so much, it worked great. I was a little nervous at first but it held well and later was very easy to remove.

[@TheOtherGuybo]

Great instruction. Just what I needed to know. I have no chuck so the use of faceplates are prominent in my turnings.

[@SusanGardener]

Did you ever publish the video explaining how to get the joint apart?

[@Wwgoa]

Hi Susan. Here you go. www.wwgoa.com/video/separating-bowl-paper-glue-joint-013218

[@SusanGardener]

Thanks! I'm a luthier rather than turner but I think that technique could have wider uses