Vauxhall Opel Corsa C - Auxiliary Belt Replacement and Tension Drive Belt How To

[@stephennoel5452]

And as for the comment on focusing I looked for ages to find someone who would actually show what there doing with good commentary and this is by faaaaaaar the best demonstration you will find!! Good job lad✊🏾

[@martinfergusson7987]

Thank you for this. I have replaced my water pump and just need to replace the auxiliary belt. I couldn't get a Haynes manual today and wasn't sure how the tensioner worked so your video has been very useful.

[@trevorbroadhurst7794]

Thank you for this video but it would've been helpful if you showed us how to adjust the tensioner. I spent ages trying to put on a new belt. I had the tensioner held as far back as it would go but the new belt just wouldn't fit. I eventually discovered that you could adjust it with the bolt just above the little wheel.

[@jamesmcrory3419]

I’ve done this job on my Corsa D, I would say the 2 VERY important things you need to do before you even put any limbs near that belt or any moving parts is disconnect the battery negative terminal just in case because if the belts moves for any reason no hand anymore. NEVER get under the engine once that mount is undone

[@trevorbroadhurst7794]

There is no need to disconnect the battery, just don't put the keys in the ignition.

[@johncollins8304]

Hero. You helped me change crank sensor. Unfortunately that didn't get my engine started. Now trying to find out how to check for spark at plugs. Can do it on garden machinery but not these modern cats!

[@alderheetooks963]

Top lad no messing about just shows ya the job. I'm not sure about using the word Guys too much, you sound like my kid making a tik tok haha. Great vid bud

[@michaelthompson1721]

Really helpful Sam , thanks fella !

[@metsy1266]

This is really informative, Sam. Thanks very much!!

[@stephennoel5452]

I’m struggling to remove the engine mount bolt with my cheap socket set, I’m trying to change the alternator but I’m also struggling to see where to unplug the power. It’s so tight in and around the 07 model!! Any advice for a noob 😬

[@andy_v4443]

nice one sam, did this about 5 years ago, on a mate of a mates corsa, from underneath, without removing the engine mount, was on the road side and they had no jack, never again will i do it that way, cracking video mate.

[@jasonswart6837]

You cannot do it without taking the mount off... As the mount runs in the middle of the belt.

[@mitchftw9228]

Where abouts did you jack the engine on?

[@1NELIFE]

Middle of the sump mate

[@niteblaster1]

brilliant 😎 thx loads😃

[@hamayoon3401]

I have done mine long time ago but if u change the belt u better cut it off

[@Mahokaevanda]

Your camera is not focused on what you are saying ,you are very fast ,you didn't show how you remove the box.othereise it could be great video.

[@stephenaltoft6792]

Much better with the volume turned off