vcds error 2

[@SzFeri]

The problem in a can system! Can: not ready!!!

[@olivercardena228]

A mí me está sucediendo ese mismo problema en un vocho, con ignición abierta si entra, pero en marcha el motor no entra, el problema que me está causando es mi alternador, en los pines del DLC, está metiendo más voltaje de lo normal en la señal de línea k y el cable se sobreprotege

[@bencrosbie]

I get interface not found

[@abdullbasitosman5070]

but what about a message says status :failed self test ?

[@ruanreryssonferreirasilva5612]

estou com este problema agora, e não consigo resolver, não conecta em nenhum módulo, percebi que só conectar aparece está mensagem após o teste, vcds CAN: Não pronto/a/s.

[@metalpaint1]

man did you solve problem. i have same problem. what to do.

[@paveldrda3956]

No, I must buy another cable

[@inspiracao8395]

Meu cabo vag kkl nao reconhece a central do carro como resolver isso

[@macielchagas2180]

Mano, estou com o mesmo problema??

[@inspiracao8395]

@@macielchagas2180 boa noite e resolvi meu poblema

[@macielchagas2180]

@@inspiracao8395 poderia me ajuda?? O meu na hora de fazer o teste da K1 ok, K2 ok, e CAN: not ready.

[@faybeniful]

hola buenas as conseguido hacer funcionar el programa yo tengo el mismo problema a que se debe

[@walidelouahabi1329]

Hola buenas podiste solucionar el problema ?

[@faybeniful]

@@walidelouahabi1329 No lo he conseguido, lo he dejado asta comprar otro.

[@RossCanpolat]

plug in the cable into the laptop & car, start your ignition and then run VCDS. open options and look for KWP (under CPU) select the top box 1281. then run a "test" and click save. after that go back to the module that wouldn't open and it should read. you are basically slowing down the CPU so it can connect to the module because the module can't send/receive data quick enough.

[@jacobhetu8423]

Ross Canpolat looks like you're the only competent guy around is there any chance you can post a video showing that's working... Thank you Buddy!!!

[@joshuaunderwood2185]

Mine still not working bud what's next?

[@TrustableGuy]

port test does not work even after kwp1281. port status ok, library version 03.02.07, driver version 02.10.00 interface not found. running a windows 10 64bit, vcds 17.1.3

[@RossCanpolat]

Jacob Hetu ok, so after you select the lower CPU speed go to autoscan and manually select your vehicle model

[@RossCanpolat]

RPrevolution25 see my comment to Jacob

[@GUGA1749]

que es lo que haces man, lo resolviste o no ?

[@walidelouahabi1329]

Creo que hay que comprar otro cable no ?

[@eveerdiaz5942]

Quiten el estéreo pirata que tienen y les funcionará 😊

[@theultimatefashion4492]

Alguien me ayuda me sale en el test can: not ready

[@crigeorge9549]

bad firmware of atmega162.

[@abdullbasitosman5070]

I do test a message says status :failed self test what happened to atmega firmwate and how to solve it?

[@ThaiEgho]

how was this solved?

[@RossCanpolat]

ThaiEgho yea I'll upload one today