Velotric Summit 1 E Mountain Bike Reviews

[@theridewithlance]

Get The Velotric Summit 1 Here: alnk.to/aLIMuhc Use This Discount Code At Checkout: lanced2v1rv60

[@vanhainguyen439]

What a nice and energetic riding a bike trip, wonderful and cool activity

[@theridewithlance]

Thank you 🤗

[@philrc1]

Great feedback on that bike.

[@theridewithlance]

Thank you.

[@caddy2long]

Nice. I replaced my handle bars too. Great bike.

[@theridewithlance]

Yeap, lovin it so far.

[@terryrccrazy6993]

Nice looking bike, good ride

[@theridewithlance]

It does ride nice, just need a little more rise on the handlebars. It definitely is a quiet riding bike and very nimble.

[@909Kodak]

Some of that rattling noise you hear is very, possibly the chain. Upgrade the derailer. As far as the kickstand goes, I wonder about a sniffer spring.

[@theridewithlance]

After this video I did remove the kickstand. But, there is still some chain noise, and I will be upgrading the derailleur.

[@909Kodak]

Try a deore 592

[@theridewithlance]

@@909Kodak 👍

[@ericrobitaille6867]

Curious if you had to sacrifice the headlight to upgrade the handlebars? I've read the headlight on the Summit 1 is integrated into the stem.

[@theridewithlance]

The headlight is attached the the handlebar clamp, and the wiring goes into the steering tube. Its just a matter of taking it off the handlebar clamp and unplugging the headlight. I could put it back on if I wanted to. So no, I did not have to sacrifice the headlight for the handlebars. I just choose to leave it off for now.

[@SteveMaas-p4g]

Can you tell me what set of handlebars you used and any special things needed to switch it out.

[@theridewithlance]

Here is the link to the bars: amzn.to/49nmUc4 They are from a company called Gewage and I used the 31.8-90mm Rise set. I did not need anything else. Used the same stem that came with the bike and swap all the controls over to the new bars.

[@SteveMaas-p4g]

@@theridewithlance Thank you Lance. Do you think the wires are long enough on the gear to use the 120 mm bars. Raise it up another 1.5 inches or so? Thanks

[@stevemaas810]

Do you think the wires are long enough to use a 5 inch rise on the handlebars Lance?

[@theridewithlance]

@@stevemaas810 I looked at my setup with a 3.5 inch rise. I looks like control panel on the left side, including the brake might ot have enough slack to raise it another 1.5 inches.

[@SteveMaas-p4g]

@@theridewithlance Thanks Lance. You had mentioned wanted to raise yours another inch or so higher. Found a set of handlebars that should put the grips at 5 inches vs 3.5 inches height that you are aiming for. Should sit someone up in a straighter position.

[@philrc1]

I sure like bleeding Shimano brakes a TON more than SRAM style brakes.

[@theridewithlance]

I will have to take your word for it on this.

[@Chef-Chad]

your seat is to low

[@theridewithlance]

@RetiredTSgtUSAF Yes it was. I did raise it.