Awesome comparison video!! Thank you, I’ll purchase this soon!
@scroogemcdooge Жыл бұрын
Hey his hanger isn't attached near resonator @2:07 Could hook something on the ground and cause a lot of problems
@VampyreX13 Жыл бұрын
He has the J2 exhaust on there. I let him know that it's not connected. It doesn't appear to have any sort of ribbing to keep the hanger in place and it doesn't look properly aligned, so we may need to take a hammer to it.
@1of1.9226 күн бұрын
I live in a building that has a sliding gate and I scrape on the rail all the time do you think it’ll work if u put it over the rail ?
@VampyreX1326 күн бұрын
Hard to say without seeing the rail, but possibly?
@neednone4146 Жыл бұрын
@kassetter_tc here. Best of luck on the transmission journey here! Good to see a new video coming out. I was planning to get the lowering springs myself too, because I want to save up for the teins down the line, but can't make a decision. Hopefully you figure out the issue with the transmission soon, did you manage to get the time to take it apart?
@VampyreX13 Жыл бұрын
Just save up and get the suspension that you really want. As for the transmission, thanks. I haven't had time to do anything with it because I'm always busy, which is also why I haven't made any new videos lately.
@neednone4146 Жыл бұрын
@@VampyreX13that's Alright, will be patiently waiting till the tC is back on the road! Much love ❤
@neednone4146 Жыл бұрын
@@VampyreX13Also, where did your friend get the rocket bunny front lip? I can only see the full kit
@VampyreX13 Жыл бұрын
He bought the entire kit.
@neednone4146 Жыл бұрын
@@VampyreX13 😱 that would have def been costly
@phantomcomposites5534 Жыл бұрын
🔥🔥🔥
@rmat9023 Жыл бұрын
how do you bolt the ramps to the ground? I m a n00b, I guess you need some super power tool to do so.
@VampyreX13 Жыл бұрын
Drill your holes and install the bolts. They expand at the bottom to secure themselves in the hole.
@raknoknak5 ай бұрын
Did you install it? I have the same question... not sure if the regular drill I have at home is going to drill through concrete
@VampyreX135 ай бұрын
You'll need a masonry drill bit.
@tmcbride9435 Жыл бұрын
Oh no; do you have the "input shaft bearing failure" too?
@VampyreX13 Жыл бұрын
I actually had input shaft bearing replaced 2 years ago. This is a different issue; the shifter no longer stays in place when I put the car in gear. I checked and found the shifter spring and lock pin were destroyed and the remains had fallen inside. I replaced both of them and tested, but it didn't fix the issue. The means the spring and pin breaking were the result of something that happened inside, so I need to find time, money, and a mechanic with and open schedule to repair / replace it.