Those are innovative construction techniques using the solder to assemble strips of metal into a progressively thicker final product. And changing the shapes on each layer, depending on what's being done, would otherwise be quite impossible. Bravo and Merry Christmas to you and your family sir!
@RonaldWalters201017 күн бұрын
Good show as always. Merry Christmas Mate!
@andybelcher17674 күн бұрын
Beautiful job David
@barumman14 күн бұрын
Top notch my friend, well done.
@RetroSteamTech18 күн бұрын
The detail work on this little loco is quite impressive, very nice job 👍👍👍 Cheers, Alan.
@nobbysworkshop18 күн бұрын
Amazing work David, especially soldering the brass parts together. Using the hot air gun was clever. Not seen that done before. Another tip to file away! Merry Christmas and a Happy New Year to you and your family. Cheers Nobby
@Mr.T-HUX7 күн бұрын
Como siempre increíble! Muchas gracias por su videos:)
@BruceRobinson-tz8cj13 күн бұрын
Looks to be a smooth runner!
@planeflyer2118 күн бұрын
Always good to see your new videos. Awesome to see the ol' Myford again in this one!
@alainlepilliez526518 күн бұрын
Really good job !
@Lechoslowianin5 күн бұрын
Dobra robota
@HaraldFinster18 күн бұрын
Good use of "old school" and "high tech" techniques.
@havellandischekleinbahnag17 күн бұрын
How thick was the material you cut with the laser? Pretty nice 👍🏻
@myfordboy17 күн бұрын
0.5 mm
@lornablewettandlee50418 күн бұрын
Did you make the springs in brass for the axle to use as a bearing? I wondered if they could have been 3D printed with room for a small brass bush.
@myfordboy18 күн бұрын
The spring detail is a dummy. There's is a real spring leaf inside. 3d printed parts would melt on a steam loco so I can't use them here!