VOTOL calibration mode

[@epowermaintenance5333]

Thank you the only one that made sense to gain access to calibration mode 👌

[@muhammet6152]

Does the controller adjust the motor settings when using the calibration mode?

[@jusubbidiy]

I think you need to use external meters to measure voltage and current.

[@muhammet6152]

​@@jusubbidiy Is the calibration mode just for adjusting the current and voltage?

[@jusubbidiy]

@@muhammet6152 I think there is more, but you have to know what you are doing :)

[@YK-Trades]

When should you use calibration?

[@jusubbidiy]

@@YK-Trades I think only if you have some problems.

[@fiwel807]

when the reset button is pressed why no changes occur

[@jusubbidiy]

I don't know. I haven't used that.

[@loopy2098]

i am having a issue where my settings do not save even though i am getting a sucess count when saved i turn my controller off come back later and turn on and the settings went back to the original ones any ideas?

[@jusubbidiy]

Do you mean model number? It stays same what ever you do.

[@loopy2098]

@@jusubbidiy no , when i prama write and save the config when i load next it doesn't save my previous settings it just reverts them back to the original the display page is now showing a hall fault

[@jusubbidiy]

@@loopy2098 did you close program and power off controller after param write?

[@loopy2098]

@@jusubbidiy it only works if i use the debugging software so its all good now ig

[@ModernizationMod]

Missing calibration button

[@jusubbidiy]

Sid you remove 0 and put ~~

[@ModernizationMod]

​@@jusubbidiyyes i use wrong software. Now it showed