According to Holden , to remove hoses , push the hose on to the connector, depress the two plastic tags on the sides of the connector on the end of the hose and pull the connector off. No tools required.
@mwoods2062 Жыл бұрын
Yeh I'd say your right, I will try it when I change the adventra one.
@fromthearea31479 ай бұрын
Correct procedure 🫡
@dmystify13817 ай бұрын
the problem is,that there is a little 'nub' underneath the top,which holds on to the rubber ring...either file it off or have another person use a strong piece of flat wood against the top lip pushing down so it will seal and you can get the circlip on.The Original part does not have the 'nub' underneath which makes it completely flat and easier to fit.Always use Genuine Holden Parts.
@mwoods20627 ай бұрын
Thankyou very much for that information. I couldn't work out why the Goss pump was so hard to get in. Thanks again.
@jimmysavage8888 Жыл бұрын
Awesome bro like the way you took the liner out.I use a bit of garden hose to disconnect the fuel lines
@mwoods2062 Жыл бұрын
Thanks Jimmy, the garden hose sounds interesting
@makeyourself19849 ай бұрын
I wish my crewman was this easy.. 😢😂
@bonesXU12 жыл бұрын
Ace vid, nicely done..
@mwoods20622 жыл бұрын
Thanks mate
@Rotors-LS2 жыл бұрын
Already done this, but still excellent content. Can I sponsor you a powered ratchet drive? That took longer than necessary. Loving your work mate, thanks for the content
@mwoods20622 жыл бұрын
Thanks mate, if the camera wasn't on all would have gone well but as soon as I start filming the wheels fall off
@gjcarr29912 жыл бұрын
good vid mate
@mwoods20622 жыл бұрын
Thanks, didn't go to plan as usual
@anthonyreading24814 ай бұрын
Did it leak?? I have just done the exact same thing as you, used the old o ring on the new pump because the new one was too big.
@mwoods20623 ай бұрын
No, I haven't had any leaks
@fromthearea31479 ай бұрын
Has anyone got the part number or a link to a replacement vy ss Ute fuel pump I trying finding it comes up with 40 different pumps (confused)