W204 2008 Mercedes C200 Kompressor | Timing Chain and Camshaft Sprocket replacement | 2024 | How To

[@usamasaleem7457]

Very good service! Repaired and fixed my commodore within 36 hours, major timing belt issue resolved. 100/100 recommended!!

[@Deathunter-nc9nj]

Pro job, pro video, thanks!

[@braybrig]

Glad you liked it!

[@mohdnasirsalleh5056]

Good job..but its good to apply some engine oil on the new timing change before fixing all the components..the early star will be much better and smooth..tq

[@braybrig]

Thanks. I did lubricacte the chain before installing the cover.

[@brainosolutions]

Good job 👌

[@GustavoVegliaVicO.M.]

there's no need to change the crankshaft gear too? doesn't it get damaged by the loose chain?

[@braybrig]

That gear is very strong and hard, it doesn't get damadged that easily.

[@GustavoVegliaVicO.M.]

@@braybrig hey. thank you very much. i was trembling in fear of having to replace the crankshaft sprocket. my car works perfectly except for the noise at sold startups, so i'm guessing it's still synchronized. I will replace the other parts next week.

[@Stoic-of-Rome]

How to change the tensioners?

[@braybrig]

There was one tensioner which can only be accessed by removing that rubber gromet on the bottom left side of the timing chain cover. That gromet needs to be repalced everytime you remove it.

[@a.fauvel3932]

ow many kilometers did this engine have at the time of the chain replacement ?

[@braybrig]

228,000 km approximately

[@amitbhusal2510]

Intake Camshaft is not lining up on mine. How do I line it up?

[@braybrig]

What step of the process are you on?

[@spannermad5246]

So the crank will turn freely with tinimg tool on you don't need to relax the cam's

[@MrSCOOBY26]

What about the sprocket further down that you're spinning the old chain on to bring the new one up? Why not do the whole lot instead of half a job, the left and right guides as well as the top one. Only doing the chain is only half a job 🤷 good job this isnt my car.

[@Raphaëlmulajmwangal]

Bonjour lngenieur

[@nicksharp9122]

This is a very complicated job.

[@mentesanaincorporesano]

Bellissimo sto video, mi piacerebbe fare questo lavoro ma ho paura qualcosa vada storto, l ultima volta che ci ho messo mano ho solo cambiato le guarnizioni delle punterie. Ma come si fa a togliere ad esempio la pompa del servosterzo (va smonstato anche il tubo o semplicemente spostato per avere manovra? Nel caso lo avessi smontato Il liquido va rimesso dopo?) e poi non ho mai lavorato sulle catene 😅

[@braybrig]

Just remove for manoeuvre.

[@mentesanaincorporesano]

Grazie per il commento a risposta, i pattini guida non li hai sostituiti vedo come mai?