WALL PANEL INSTALLATION | How To Fit Tongue & Groove/Farmhouse Wall Panelling | Easy DIY Tutorial

[@Skirting4U]

Tongue & Groove Wall Panelling is available on our website: www.skirting4u.co.uk/wall-panelling/tongue-groove-mdf-wall-panelling

[@oliverwheatley8596]

Don’t normally comment on videos like this, but just wanted to say how helpful I found this. Thank you!! Oli

[@aidylyall883]

Very helpful, thank you

[@thebigfatquizco]

Absolutely brilliant instructional video. No fluff, just info. Well done.

[@garico7464]

really helpful that, Thanks.👍

[@Skirting4U]

no problem 😀

[@jnazarian113]

Great video! Exactly what I want to do. Whenever you are nailing them in, are you not concerned with finding studs so they are secure? Or electric ⚡️ cables?

[@cameronharris8400]

How did you fasten the cut-down final board as you can't access tbe tongue? Surely it can slip down.

[@reubendiaz8951]

Good video, thanks. Is it ok to use this pinning method on plasterboard?

[@jamesmcdonald5764]

I was wondering what he's nailing to wall studs r set at 16" on center. I don't think the nailing in sheetrock is going to work. If you have a wooden Wall, yes but not sheetrock Wall cover. Use liquid nail and at least run a nailer between wall studs at the height your going to stop the boards at. Nail at top and bottom of your boards

[@michellereece7281]

What nail gun do you suggest for a concrete block wall with plaster to fix the T & G

[@Jake-i5x2m]

Hi there, whats the best way to cut the tongue and groove panels at the point where two walls meet, if panelling more than one wall. Is it worth trying to cut 45 degrees? Thanks.

[@Skirting4U]

Hey, we would recommend just butting the two panels into each other where the wall meets. Nothing is seen from the top as it would be covered by a dado rail. Hope this helps!

[@Tiswas2010]

Hi, can they be painted with a wood paint?

[@RobH-xx2nw]

What no horizontal battens?

[@r5u26d3]

What’s the best nail gun for this job? But not too expensive .

[@Insp.CountMortisWinshipKlaw]

Glue

[@jayjohal6892]

what happens if the corner wall is uneven for the last piece??

[@Skirting4U]

Hey Jay! If you watch from 2:48 we cover how to measure, cut and fit the last panel piece if it's uneven. Hope this helps but if you have any more questions, please do let us know! 😀

[@alex1975uk]

These panels aren’t on your website?

[@anakshan]

High I’ve looked at a lot of these and everyone seems to only go halfway up the wall I want them to cover the whole wall and go up to the ceiling. Is this the same concept or different?

[@Skirting4U]

Our Tongue & Groove panels come in 3050mm lengths so you would be able to achieve that look. You can view them on our website here: www.skirting4u.co.uk/wall-panelling/tongue-groove-mdf-wall-panelling

[@DeclanCrumley]

Why do some people use backing laths ?

[@kulsumbibi7907]

How much would this cost with labour

[@Skirting4U]

This is something that you would have to discuss with a carpenter as prices can vary

[@alex1975uk]

These panels aren’t on your website?

[@Skirting4U]

Here's a link, Alex: www.skirting4u.co.uk/wall-panelling/tongue-groove-mdf-wall-panelling