WEBINAR: A Guide to Land Rover Suspension Calibration

[@alvarofaria4793]

The best suspension class I’ve ever seen.

[@luizspecialist]

Thank you Duncan Well Done!

[@alvarofaria4793]

Grande Luiz! Exatamente a falha que minha viatura está apresentando (sensor traseiro direito) Logo ela estará com você para me salvar!😂

[@williamshanasy2288]

Thank you Nice work

[@marekkremen852]

Hi, my defender always levels itself so the front is -1degree (on a flat surface). Dealer checked everything, no errors analysed, no hardware issues either. What would you recommend? I compared it on the same surface with another defender with air suspension and the lowered front is immediately visible. Thanks for any advice

[@donwk1892]

I have a 2006 rrs supercharged... My car was fine and out of boredom i selected calibrate anti roll option then i got e 7 error code and my red suspension light is on... Everything still works ie suspension goes up an down etc but now the red light stays on and fault code C 1 A00-54 - Control module - System programming failure - missing calibration (AB)... 😮... Any advice please 🙏

[@andyweeks3028]

Great vidio

[@sulmonjb1376]

Great video learnt a lot. My range rover sport drops over night. Mostly the 2 front shock goes down completely. Back shocks are okay. Dont know what to do

[@skaro1]

Get a water bottle with some soapy water and spray the inlets to the front air-line to your front airbags. See if there is any leaking at the inlet where the tube is inserted. Could be a bad o-ring and leaking air. If not there, then most likely culprit is the front valve block leaking back to the pump. You have a couple options if this is the case, replace the front valve block or you can try and replace the o-rings on the OEM. Search the internet for both options How-to. I haven't tried the aftermarket valve blocks but I have seen some for less than $50 with mixed reviews. OEM is pricey, but there are some aftermarket that are in the $150 with very good reviews.

[@billybob1511]

I got a brand new Defender and the ride is firm. Could it be in tight tolerance mode? Do they come from the factory like that for transport?

[@andyweeks3028]

My l320 keeps telling me to clear obstacle So stays in extended mode. Changed compressor and all 3 valve blocks. All corners are reading roughly the right hight Any ideas please I'm sick of throwing money at it.

[@paulhoppe4596]

Do you know the correct height for the new Defender's (center of the hub to wheel well)? I have a 2022 and would like to double check the height. Thanks!

[@AutologicTV]

Hi Paul, Sorry we cannot find these values on Land Rovers technical information site! Only road to roof height

[@user-pm1tk1cj6p]

👍🇺🇦

[@AhmedAli-hu8ng]

Very informative video but voice to low boss don't mind and thanks allot