WeCreat MakeIt! Ver 2 0 7 Part 2 -

[@lynncamomile5025]

Thanks, Lonnie!

[@charlenechoate17]

Spacebar will also bring up the hand. 😊

[@gizmobowen]

Thanks for this tip. I've been searching for a quick way to jump between the select tool and the hand. I am always wishing there was keyboard shortcut or something. I'll be using this a lot.

[@charlenechoate17]

Thanks so much!

[@gizmobowen]

Sorry for commenting so much, but I think your videos are helpful, but then I come up with suggestions or questions and I can't help myself. For the subtraction tool, I am confused how it works. For example, when you put the circle on the rectangle, it subtracted the circle, but it could have subtracted the rectangle and I didn't know how it knows. I thought that it was a layers thing, so I went into the software and tried rearranging the layers. Unfortunately that didn't seem to change things. Then I was looking for an arrange feature to move them forward or backwards. From what I can tell, new shapes are placed above the previous shape. This then creates a scenario where the software subtracts the top shape from the bottom shape. What's even weirder is that I had three shapes, selected all of them and the top two disappeared from the lowest shape. Without the ability to control the arrangement, you're stuck with the order that you put them on the workspace. If the software people can add the arrange feature, or make it tied into the layer definitions, that would be helpful.

[@gizmobowen]

One suggestion I'd give for the test arrays deals with how dark the text is. Normally the text is too light for me to read, so I have to ungroup everything and put in my own settings for the text. I'm not sure why the values are so low, by default, but that's what I have to do.

[@prayingkoala]

Rotate? My software( i check every time I use my laser) which says it’s the most up to date, doesn’t have this! I am surprised. I think there are various versions and we all don’t get the same updates.

[@jimlincoln5617]

Why does my laser continue to say Failure to Refresh the Background?

[@WeCreat_Lonnie]

mines done that before run camera calibration again, solved my problem, wecreat has a page on that ( refresh camera failure )

[@jimlincoln5617]

@ thank you so much