Weedo ME40 3D Printer || Unboxing & First Impression

It has been a few months since I've had a 3D printer unboxing & first impressions video on the channel! So I am pleased to show exactly that here, this time with the Weedo ME40.
At the start of the year, I reviewed the Weedo X40, their first IDEX 3D printer. The ME40 (in this video), offers a simplified single extruder design with some iterative improvements over the earlier X40 printer.
This printer is available direct from Weedo @ $429.
In the UK, the printer can be purchased from Amazon @ £429 (there is currently a £100 off voucher, which brings the price down to £329):
Amazon link below:
amzn.to/3Ut8q2t
I hope you enjoy the video! Smash that like button.
Spec check:
- Build volume: 300 x 300 x 400 mm
- Bowden
- Max. hot end temperature: 295 ℃
- Bimetallic Hot End
- Max. heated bed temperature: 100 ℃
- Print bed material: PEI Flexible Magnetic Bed
- 5 x 5 Point Automatic Bed Levelling (Magnetic Probe)
- Filament Runout Sensor
- Power Loss Recovery
- 4.3" Touchscreen
- 32 bit Motherboard
Don't forget to subscribe and ring the bell so you are notified when I post more videos like this.
If you enjoyed this video and want to support me here's the link for 3DTomorrow Filament: 3dtomorrow.com/product-catego...
Or if you're outside the UK, here's the link to buy me a coffee: www.buymeacoffee.com/callumcoles
#Weedo3D #3dprinting #unboxing
00:00 Introduction
00:30 Printer Overview
01:30 Unboxing
03:25 Setup
10:54 Switch On Time