Acceptance criteria for DPT and MPT as per ASME Section VIII Division 1.
Пікірлер: 20
@rajendharbyri74374 жыл бұрын
Tq for your efforts, brother please do videos on asme each section clearly
@abderrahmanebenabdallah6725 жыл бұрын
thank you very much
@gopi172965 жыл бұрын
Sir why this case of relevant did not come in radiographic test acceptance criteria?
@avitsalutigikar59813 жыл бұрын
Please do video on acceptance criteria for visual inspection as per asme sec viii
@Mstrdj0072 жыл бұрын
Sir please show linear & Rounded indication on Test piece
@panneerselvameswaran97544 жыл бұрын
How about acceptance criteria from AWS D1. 1
@sudhakarjodagudri22814 жыл бұрын
If four or more rounded indications separated by 1.5mm or greater than 1.5 mm(eg 3,4 or 6mm etc) Then how to evaluate....please let me know
@snakebaboo41165 ай бұрын
Four or more rounded indications separated by less than or equal to 1.5mm is rejected. If there are separated by more than 1.5mm then it's not applicable. Hope you understand.
@bangariprasad734 жыл бұрын
Can you pls explain acceptance criteria as per B 31.3
@trinityworld26508 күн бұрын
Same
@Funnyvideos-vz9qm5 жыл бұрын
Useful.....
@WeldingandNDT5 жыл бұрын
Thanks. Please visit my website www.weldingandndt.com
@ArifHossain-dk5mc Жыл бұрын
sir plase make one video, mpi acceptance criteria for aws d1.1 table 6.1
@abhss3 жыл бұрын
Thank u sir
@WeldingandNDT3 жыл бұрын
Thank you. Please visit my website www.weldingandndt.com/
@saikatroy76464 жыл бұрын
Sir kechu suggestions chahiye
@WeldingandNDT4 жыл бұрын
Thank you. Please visit my website for notes, videos and other important informations www.weldingandndt.com/
@nikleshshahu93713 жыл бұрын
Acceptance criteria for ut and mpt share or upload please