What is Varistor

[@awaitingthetrumpetcall4529]

I had to click through a lot of videos before I found this. 'This' video shows what it does, where to place it in the circuit, how to read its value and how to test it. Thank you! 👍

[@passiontechklm]

@@awaitingthetrumpetcall4529 You are welcome

[@marksplace]

Thank you very much sir, very well explained. After watching a few other videos my research is finally over thanks to your video.

[@passiontechklm]

@@marksplace I am happy for its helpful 😇

[@marvinhenry1027]

Best explanation I've seen so far

[@passiontechklm]

Thank you so much

[@drengrd]

Thanks... Well explained with a good example. This is excellent explanation. ❤

[@passiontechklm]

thank you brother

[@seremaiarabaraba296]

well explained... good job 👍

[@passiontechklm]

Thank you 🙂

[@mrtechie6810]

For 220-240VAC -- Should I use a 431 or 471 volt MOV? What would be the difference in leakage current at 240VAC?

[@passiontechklm]

you can use either 431 or 471 for 240vac but for more safety 431 is more recomend to use which will protect more safe for your circut board.

[@arkapadma]

@@passiontechklm what about 20D391K vs 20D471K?

[@passiontechklm]

@@arkapadma 20D391 is more protective than 20D471 if you are using in 230vac circut board.

[@arkapadma]

@@passiontechklm thanks a lot.

[@safasdaasdasgfafs]

Is it still safe if we connect the varistor to L and N without fuse?

[@passiontechklm]

No safe, fuse is necessary calculated by load Amp since varistor is for surge protection so it must be both use .

[@kirkberryleo3307]

Sir, you are my new Hero. Im a novice in electronics and its my reg pwr supply Im trying to repair. My multi mtr showed nothing..my Esr mtr showed nothing and my component tester nothing.

[@avnerabulash]

Make subtitles in Hebrew as well. thanks.

[@Anthony_The_Chicken_Licker]

Sucker board _😂😂😂_

[@passiontechklm]

@@Anthony_The_Chicken_Licker My bad 🤗😋