WorldEater for bedrock edition : Tutorial

WorldEater for bedrock edition
~~~~~~~~~~~~~~~~~~~~
Subscribe if you want to watch more videos like this.

[@gavonsutphin1378]

World Eater Material List Slime Blocks:8 Observers: 6 Sticky Piston:3 Regular Piston:3 red stone: 1 stack red stone repeater: 1 red stone lamp: 1 red stone comparator: 1 chest: 1 hopper: 1 dispenser: 1 Obsidian: 1

[@gavonsutphin1378]

and 1 lever

[@Pat24123]

And 1 slab

[@Hectilli0n]

And many tnt

[@aprilbrandon3441]

Ty

[@Flat_pancake675]

I swear this guy is getting more subs every day I really hope he gets to 1k subscribers soon he deserves it

[@tricky2917]

It's incomplete without the water sweeper and the lowering mechanism, isn't it?

[@jenv.7995]

This channel is actually awesome. Thank you, internet stranger, thanks a lot for showing what you are doing

[@OhCDeer]

Actually surprised this works so well, and is relatively easy to build. Great job, you earned a sub 👍🏼

[@Danny7]

Subscribed!! Amazing video only decent TNT Flying Machine I could find for Bedrock thank you so much

[@BspPlays9287]

I like the way points to activate the dropper. Neat concept 👌

[@boneswest]

This is actually such a smart design and I was wondering if instead of the torches if u could just use red stone blocks

[@ArthurMorganGames]

Yes you can

[@charlesgoodman5101]

Just built this on Bedrock 1.20 in survival on my Xbox, works great.

[@christopheranderson5446]

So I'm running this amazing machine in my realm , I've ran into a couple problems, turning machine on an off is a pain in @#$, getting out of render distance all bad ( if your machine are stuck mid air, the top observer, pit a red stone torch then remove it, should get it moving again. Also a height issue because TNT is primed, doesn't go as far as I wanted it to, gonna have to do 2 layers of this machine haha so one off an primed TNT height distance but good machine thou once you get use to it very helpful

[@andresmiranda2715]

Can I make the stoppers longer than the designated range?

[@Maltez360]

How many flying machines would I need to make a 257x257 perimeter?

[@cobia48]

Nice concept to activate the dispensers to save on TNT

[@Boatsnack7777]

Note to builders: if you are not following the build order. first put the obsidian stopper up on the other side. Or you may be chasing your flying machine. Rookie mistake I learned the hard way

[@obscure_genesis]

Well, obviously lol. Still a good reminder because if this does happen to anyone watching it could be painful for them, or maybe not who knows.

[@charmjkgaming1051]

Bro you can put 1 1 dispecer in both sides i upgraded it so in my model you also dont need chest hopper and that ugly line

[@yourhost9616]

Join my Patreon - www.patreon.com/YourHost

[@SirSkyro]

Hw many wouldit take to blow upnthe end?

[@aprilbrandon3441]

Thanks

[@thezeldacrafter9826]

After I build my own red stone designs I watch other peoples videos to compare mine to and yours it top notch

[@l0l_h8d_l0l5]

I thought he had 625 k subs 😂how does he have less than 1k

[@jylix]

So does the machine also duplicate the tnt or do you need to manually place stacks of tnt in to the dispenser?

[@yourhost9616]

u have to place manually

[@Danny7]

@@yourhost9616 Wouldn't be so bad if they made Sand farmable

[@redneckscience5338]

@@Danny7 you can make a sand duper

[@Danny7]

@@redneckscience5338 true

[@benitoaversalescure9748]

1.19 bedrock?

[@cristopherperez2660]

Main Build: 8 slime blocks 2 obsidian 4 glass 7 observers 8 redstone 6 blocks 1 comparator 1 repeater 3 sticky pistons 2 pistons 1 slab 1 redstone lamp 1 chest 1 hopper 1 dispenser 1 lever Extension: 5 blocks 4 redstone 1 redstone repeater Multiple blocks and redstone torches depending on how far you want it to go

[@augustkelley]

Ty

[@darklorderic7208]

Do you know how many flying machines need to be put next to each other to mine out something 100 blocks wide?

[@thomasloring8725]

I's say between 10-15 maybe more depending on the spacing in between the machines

[@nolanmauney4864]

Block list ?

[@thesuperman0622]

Sure wish there were a material list to help me gather beforehand, otherwise its too complicated watchig the video over and over to try and get everything.

[@wilbibe]

Bro, he pin it on comment

[@sathvikop6832]

Thx bro

[@slitherixxx]

how to make it go 1 block down after first sweep? do i have to rebuild it but lower?

[@shanemcquillan4804]

yea

[@catosicarius9334]

any way to not use the torches bc that's a hassle in survival??

[@TurzoMC]

Redstone blocks are probably the only cheap sollution.

[@carsonmcbroom9426]

can you use honey

[@swankgodd3647]

Works great. Is there any way to increase the amount of TNT dropped? Either more TNT or faster drop rate?

[@thomasloring8725]

You could maybe place the restone torches more frequently? However, i would test first just in case it blows other tnt away

[@TurzoMC]

The minimal grid desgins, always have about 5 blocks of space between each redstone block or torch. Any closer theres a chance the, Tnt might blow other tnt to your modules right at the begening.

[@Vxgkdgdydkdjf]

I know this is a really late to tell you but you could build it higher I don't know how high but definitely higher than the guy showed in the video and then you could place redstone torches more frequently, making the process faster. Hopefully that was a good explanation and can help you in a way I guess....

[@Elchut7]

Well of course yeah you can redefine a signal through slime blocks which then observers can attach and as the machine moves it'd send 2 signals one to a dispenser facing downwards and the signal gets too to the piston

[@Elchut7]

@@Vxgkdgdydkdjf yes you're very truthful here but it must have a redefined connecter that pulls the main layer downwards 1 block so the tnt reaches its target. Yet it would not be as much efficient. Because the process could take more than 30 seconds for a big perimeter. And because the tnt would not be good because it would blow up almost when it reaches the ground. The main tnt machines must be pushed more than two blocks depending on the terrain and the size of s perimeter

[@mof6422]

how deep can this dig? yall the way to bedrock?

[@creamy_king_ontiktok4471]

Will it be Laggy for Xbox one s for 220x120

[@SirSkyro]

Bruh

[@christopheranderson5446]

How did it do for you? I'm doing this with 200*200 down to bedrock, currently setting up a 21 module design pretty isane honestly lol

[@creamy_king_ontiktok4471]

@@christopheranderson5446 sorry for the late reply it worked fine but only did one module at a time as that’s all my Xbox One S could handle

[@lukedean890]

Is there anyway how I can ride with the machine

[@TurzoMC]

Yes boats or lose minecarts.

[@Danny7]

@@TurzoMC if you do this can you extend it as far as you want?

[@TurzoMC]

@@Danny7 Well as long as it's not out of your simmulation distance. If it goes out of your simmulation distance, only the parts inside will work.

[@Danny7]

@@TurzoMCI already tested this and sorted it now thanks

[@TurzoMC]

@@Danny7 Good to know!

[@jojo_glitching2970]

Show to design in discords with your link. Don't beg for subs and you'll get to a 1000 in no time

[@m2lansky]

It does seen not so efficient.

[@toxiccrafts7102]

U can extend it

[@kerbynelson6406]

Honestly bad vid but got the job done would have loved a materials list 👍

[@schonandfriends]

Bad