Wowgo / Meepo Increase Speed/Performance VESC Mod // Part 2 Replacing ESC

[@DarkHorse72]

Very interested checking this out. Thanks for all the work. If you post this to the esk8 builders forum, they would eat it up.

[@zaccaldwell]

Did you ever release part 3? Just interested in how it was tuned and how it turned out.

[@VerticalWTF]

Nice

[@yoshidis4]

Nice video! Can't wait for the 3rd part!

[@shigar24j]

I'm trying to remove my ESC currently, however I've gottene every wire out except the grey one that seems to be buried in the board at 4:28, how did you get around this?

[@gugugua]

Could you do a speed test please, I'm considering doing this but I am not sure how the performance will be

[@DroneMesh]

I think these are all 75kv however I just got the braking perfected and FOC setup correctly which is alot better than BLDC mode. The amount of torque is insane now and speed feels more maybe 1 or 2 mph not sure yet once I am 100% satisfied with the configs I'll make the 3rd video with speed results and configs. I have another identical board with same battery LG 6.4 to compare.

[@cafra78573]

Hi ! Any news on the config and follow up video ? Could be awesome to see in action !

[@tclark]

Waiting on that third video! :)

[@gugugua]

Flipsky recently announced their dual vesc on one pcb, this will lower the price and eliminate the bridging problem

[@rocheuro]

@@gugugua can you confirm.it has been released ?

[@MCsCreations]

Awesome work, dude! 😊 BTW, I bought that toolkit you showed a few time ago (I remembered because of the scissor you used). And there's a TS100 coming for me from Gearbest. 😀 (If you want I can give your contact to the guy from Gearbest that contacted me. 😉)

[@312maxon]

I searched for a follow-up to this video, found none. I'd love to know how many poles the Wowgo 2s motors use. Did you continue with this project? Do you remember from when you actually ran the motor config wizard? There's no real spec info on their site, have found only you that thought it was worthwhile upgrading to a VESC for this modest hub-motor board & documenting it. Alas, my buddy just received his Torqueboards direct-drive kit, which uses 28-pole motors, is dying to try 'em, but I don't think his new VESCs have arrived yet. If, and only if these hub motors (used on both the 2s and 3s) have the same pole count, will work just for some low-current, low-torque fun to get him "going" in his living room. So, does the OP or anyone who tuned-in know how many pole pairs these motors use?

[@miodice3]

Did you ever do a config part? I configured my vescs and the can bus connector friend them (I think they weren't fully tested prior to shipping)

[@DroneMesh]

I was riding them today.. how did you set up the motors foc or bldc?

[@miodice3]

@@DroneMesh they were not foc setup up, they were regular bldc motors (not hub motors) I configured each one independently and when I connected the can bus cable they burned out. I am not sure what could have caused that, I flashed them too with the unique ID's so the master was 0 and the slave was 1, so I wanted to see fi you did an ultra (unedited) full length video on the entire process to flash them, can bus connect etc

[@esk8spirit362]

Would you know how many max. motor amps can these wowgo motors get? Trying to figure that out... Thank you

[@brobewok2303]

Good information about attention to the solder splatter

[@bdbincorporated]

Did u bench test the vesc? Why not?

[@rocheuro]

hey great mod ! i wanna mod mine meepo original. can you confirm i could use my Esc 120A but i dont think it has a brake how to check what my esc has to have ?

[@MCsCreations]

What happened to the audio, dude? I went until the end and nothing... :/

[@ThePurplePupUwU]

MC's Creations wjat was wrong with your audio i could hear it the whole time almost

[@MCsCreations]

Here I still don't hear it... And I'm editing video here, so my audio is ok. :/

[@shozzy69]

All ok here

[@ThePurplePupUwU]

MC's Creations if your on a pc then first check that firefox is up in volume in volume mixer ( right click the little sound icon in bottom right corner) all firefox aplications and tabs and if this doesnt work then restart firefox and also mske sure that the little bolume thing on youtube page and if your on mac or not on firefox than idk if tbiz sould work since i only use windowz 10 pro so idk how it would work on your system plus ive made a few mods to firefox so yeah hope something in this helps

[@MCsCreations]

Damn it, it's ok now! And I didn't change anything. O_o

[@dreydelrosario4911]

i wish ur my brother..ur so good

[@lbabacar8653]

How do you turn on/off?

[@DroneMesh]

I just tested today.. worked great part 3 will be out in couple days I ordered hglrc anti-spark switch to properly use it.

[@CanadianDroneHub]

nice

[@redlines2535]

12:10 what was that? be careful with this guys

[@DroneMesh]

l'umanità fa schifo The capacitors on the ESC still have charge.

[@redlines2535]

I was talking about the bees

[@POSTIVETHINKING]

Ok cool 👍

[@nadoushkaautaibi376]

Nice vedio

[@bennieleip579]

And then i expect a vlog on that board to location to fly and eat mexican food afterwards 😆

[@redlines2535]

warranty avoided of the vesc

[@miniquadsmegafun3619]

First squad!!!

[@slipperysebastian]

First