WYNNS DIY TIPS: Lockwood 001 Touch - Change Combination

A Wynns Locksmith tutorial on how to change the combination in a Lockwood 001 Touch. For further information feel free to contact Wynns Locksmiths on [phone] or via our website - www.wynnslocksmiths.com.au.

[@rabikhadka5795]

Very good and informative

[@georgiezuzak6836]

Thanks for this info, I'm just wondering though how to make it silent mode? the guide says you can but no instructions. Are you able to shed light on this? Thanks!

[@ClaireMaddison-i9f]

Hi, i have tried this, but the key pad doesn't light up to allow me to enter a new code. I pressed the screen and tried, but it doesn't register it. Any help would be GREATLY appreciated. Thank you

[@WayneHopwood-i8h]

What about after master restart

[@larabzadeh7767]

Hey there I've tried several times to change the Pin following the method, but when i press the reset button it Beeps 3times and numbers on the lock pad flashes and goes away! What could be the issue? Thanks 😊

[@s.s.1132]

Thank you so much A big help you done

[@liamarmstrong8]

Thanks James

[@Justaddjack]

het there ...any advice....I've just intalled the unit (lockwood assa abloy 001) and the batteries are heating up and the unit doesn't work again until I pull the batteries out and re install??? thanks

[@WynnsLocksmiths]

Hi Jack, are you using the batteries included with your lock set? I haven't experienced this problem before. I recommend giving Lockwood a call on 1300 Lockup (1300 562 587) as they will happily help you out with what the issue going on there is.

[@laxmareddyvengati4395]

Can you help me in changing the old pw

[@KrstianTheKid]

lockwood 001 touch

[@renrocks27]

guys can you help me out... i bought an extra key card today from a locksmith and programmed it into my 001touch but it then cancelled out my other existing card. When i tried to reprogram it, it cancelled the new card and vice versa. it wouldnt let me register two cards. how do i fix this as i need more than one card for the lock.

[@WynnsLocksmiths]

I recommend giving Lockwood a call on 1300 Lockup (1300 562 587) as they will happily help you out with what the issue going on there is.

[@renrocks27]

@@WynnsLocksmiths ok thank you!

[@danicabaker8766]

You need to register all the cards at once. I got caught out with this once.

[@equinoxnoosa967]

How do I do a hard reset? I've forgotten my master pin

[@WynnsLocksmiths]

Hi Richard, a factory reset is not a simple fix and doing it yourself may void your warranty if not completed correctly. We recommend contacting a professional and qualified locksmith to assist you with this challenge.

[@equinoxnoosa967]

@@WynnsLocksmiths thank you for your quick response!