X SCARA Calibration without endstops - Marlin 2

[@FlowerPowered420]

Very good video, thank you for sharing!

[@TUENHIDIY]

Thank you for sharing your work, it's really helpful!!! I read your configuration, and I can't figure out how you calculate these parameters: MANUAL_X_HOME_POS 158 and MANUAL_Y_HOME_POS 48.

[@3D_printer_guy]

Those positions are irrelevant when using G92, because you tell the printer where the nozzle is.

[@TUENHIDIY]

@@3D_printer_guy Yes. This is an offset between build area original coordinate (nozzle) and scara home coordinate, is it right? But I didn't see their relationship?

[@TUENHIDIY]

I mean they should be MANUAL_X_HOME_POS 60 and MANUAL_Y_HOME_POS 146 following your instruction in the video (as you said this firmware for it). Is it correct? Thank you!

[@3D_printer_guy]

Theese numbers are only relevant when using homing.

[@TUENHIDIY]

@@3D_printer_guy Thanks!

[@LUIZBERTOLDO]

hi my dear. Im to do a scara j1 325mm and j2 370.87mm and I dont can it... I see your video 100x can you helpme?

[@pzachery8536]

P R O M O S M

[@3D_printer_guy]

What does this mean? 🤔