xtool S1 Conveyor

[@pmbrothny]

You could use the tab option, so that the pieces do not fall out, and then you just cut the little tabs.

[@everygooddaydesigns]

@@pmbrothny I didnt even know there was a tab option. I'll have to look at that later. I appreciate that!

[@pmbrothny]

@@everygooddaydesigns In The cut menu, you will see "Tab Generation", when you turn it on, there are alot of options for the Tab size, number of tabs, or tabs by space, etc. I just got my laser, and just testing it out, did not setup the conveyor yet, but saw these options in the software. LIghtburn I belive does not have this - thats what I have used with my other laser before it died.

[@everygooddaydesigns]

@@pmbrothny appreciate the information. It will definently make the process a lot easier

[@MrTonytony8282]

@@pmbrothny Hello, thank you for the valuable advice, I bought the p2s and it arrives in days, I have doubts about the validity of this sliding system because I would like to use it a lot especially on acrylic, do you think there are problems in cutting for example circles 50 cm x 50 cm? Can the scroll wheels scratch the acrylic panel? Thanks in advance

[@FabstaPizza]

how come when I try frame the Conveyor doesn't move at all?

[@everygooddaydesigns]

@@FabstaPizza there could be a few reasons. I would start with the software and just make sure its set on the conveyor mode, if it is then I would confirm that the USB is plugged in properly. Next I would make sure the image is selected prior to hitting frame and finally I would make sure the rollers are lowered onto the wood to pull it back and forth. (Not too tight and not too loose) if that does not work I'm honestly not sure.

[@FabstaPizza]

@@everygooddaydesignsthanks for the response! I'v done all these things and its not working for some reason, had a simular issue w the rotaray attachment where when framing it would act as if it was trying to spin it but wasn't and it was like stuck or something, still havenm't gotten that fixed either, and now this isn't even trying to spin, ill contact support about this, thank you! :D

[@everygooddaydesigns]

@FabstaPizza no problem, i had issues in the past with an IR laser and I had to get a replacement motherboard

[@FabstaPizza]

@@everygooddaydesigns really!? A new motherboard!? Dayummn that would suck, not only more money but I recently upgraded it 😭

[@everygooddaydesigns]

@FabstaPizza xTool sent it for free, just had to swap it out lolol. If you still have the warranty thsy should hook you up