Here's a long DIY video of me replacing a waterpump. I'm no professional. Hope you enjoy. Hit the like and subscribe button.
Пікірлер: 13
@conkyjoe2 жыл бұрын
Couple of details you missed. Use a torque wrench for bolts. Bolt tightening torque 12mm 6 LU 27’# (10x45mm) 12mm 1 Zinc 31’# (10x45mm) 4 water pump housing 13’# You didn’t pack the three metal washers that fit over the shaft correctly. There are three washers. The flat washers go on top and bottom. The wavy washer goes in the middle. You only used two washers. When placing the plastic part on the shaft you need to pull up on the shaft so the plastic piece is correctly seated. If not you will get prop chatter when shifting into idle.
@JimJanik-un8cs20 күн бұрын
I wonder if that is my problem from the dealership? Thank you
@thomasjohnson97682 жыл бұрын
Best one I have seen on this repair yet! 👍👍
@mattc51552 жыл бұрын
Start of with the boat in gear of in neutral?
@DavidFederLimitlessGuitar2 жыл бұрын
which brand Kit did you use?
@timsussenbach53766 ай бұрын
What year was this engine?
@PumkinHoneyBaby Жыл бұрын
Where did you buy red jack stand? Thank you
@Rotorsgarage8123 Жыл бұрын
Northern tool
@elviniqueharold9601 Жыл бұрын
Hey u thinking about selling the engine
@marymeyer1449 Жыл бұрын
You didn’t show if you filled it with outboard grease.
@Rotorsgarage8123 Жыл бұрын
Never drained the oil. so no need to fill
@samburnett78022 жыл бұрын
Didn’t care to remove old gasket material under the base plate …