Yamaha Grizzly Upper Ball Joint Replacement | 2007 Yamaha YFM700 Grizzly | Partzilla.com

[@imagoodmann]

A huge thank you for your GREAT videos also! It has caused me to shop partzilla for sure!

[@robertmertz4831]

Any alternatives for removing the ball joint besides using a press? Would a C-clamp work as well?

[@krisproc2696]

Great video . U should do a front axel diff seal replacement video . For when you replace front axels

[@billpeters8433]

I have a 03 Yamaha Kodiak 400 cc and I can't seem to press out the upper ball joint on the left side. Is there a work around for this?

[@cedricpalas303]

I buy a 2007 honda trx400, is a good quad?

[@imagoodmann]

Did you have to bleed the air from the brakes after you disconnected the line? Is it necessary to remove the line from the brake? I hope you can answer because I have a project to do Wednesday! LOL

[@PartzillaParts]

If you disconnect the line, you have to bleed it. You don't have to disconnect the line.

[@imagoodmann]

Thanks. I didn't have to because when I pulled the ball joint out I found it was the whole spindle! (My luck!) So I added a few washers to get me across some ice for a fishing derby. I hope you have a video showing the whole spindle swap out, and reconnect! Hardly know what I'd do without your videos to help!?! I have a 2016 Yamaha Grizzly 700se (hint hint!) Thanks again for sharing your knowledge!

[@alexis2223]

Hey I got a 2007 suzuki ltz90 that wont start it has good spark and i rebuild the carb and still wont start any ideas what it can be?

[@alexis2223]

It cranks but just wont start

[@PartzillaParts]

If it has spark, the carb may not be putting in the correct fuel. Check output.

[@alexis2223]

@@PartzillaParts I found out the problem I just had to adjust the valves

[@susdad]

3:02... definitely scored the threads ..

[@linkinpiatak6669]

3:02 you definitely have no idea what youre talking about...