Yamaha Raptor 660 Removing Throttle Cable from Throttle Housing on Carburetor

[@jeremylinscott9461]

Thank you for this upload! Went thru a bunch of videos trying to find a step-by-step instruction and couldn't find one until now.

[@JOATD]

No problem I'm glad my video could help. I have a couple other videos I might do in the spring on the Yamaha 660.

[@jasoncheney1215]

Thank you so much. I was lost and did a lot of extra work before finding this

[@JOATD]

Thank you so much for the positive comment. I'm so glad that my video could actually help you. Apologies for the late response for some reason your comment was blocked and I didn't know until today

[@zspence77]

Thank you for your explanation on how this is done!! Everyone else kinda skipped through the process.. Well done sir..

[@JOATD]

No problem, I'm glad that my video could help you.

[@darcyharlan5264]

Thanks man!, I want to rebuild the cards(done so on cars before). But got stuck at this point. You’re my hero today!,

[@JOATD]

No problem, I'm glad that my video could help you.

[@Bardy80]

Thanks needed the concept of getting it off for a bigbear 350. Real life saver 🙏

[@JOATD]

No problem I'm glad that my video could help you with your situation

[@juanpablotorres4511]

thank you so much for making this it was so helpful 🙌🙌life saver

[@JOATD]

No problem, I'm glad that my video could help you.

[@jasonthomas7252]

Very helpful! Thanks Dre!

[@JOATD]

You're welcome

[@aquadizz]

You the man! Appreciate your help.

[@JOATD]

No problem I'm glad that I could help you out

[@karllang8434]

Is that needed when it's bogging out .. or can you adjust the float without removing the lines ?

[@JOATD]

You can adjust the carbs without removing the cables, this video was just to show you how to remove the cables just in case you wanted to put a new carburetor on

[@terronwilkins3820]

What’s is your choke set at on you cable mines turned all the way in and I’m not sure what to set it at?

[@Itskeithbennett]

what do i do when the mechanism that flipped back on the bolt at the end doesn’t move back and fourth. i have to forcefully move it. when i lift it up it’s stuck in that position. the quad has been sitting forever

[@JOATD]

It's a spring that's inside that mechanism that makes it go back and forth and have tension on it I will try to use penetrating oil to lube it up and if that doesn't work you're going to have to replace it you can buy that part on eBay but it is difficult to take the entire carburetor apart to replace it I may do a video on that because I have done it multiple times just never thought someone would want to do it

[@dirtmasta2960]

​@@JOATD trust me, we don't WANT to do it but I want to ride and I can't afford to pay someone to fix it! Thank you for putting up videos and helping.. I'm gonna use this knowledge for on my yz250 and hopefully it's similar enough 👍

[@JOATD]

@@dirtmasta2960 no problem I'm glad that my video could help you.