Yamaha VStar V Star 1100 - Clutch Adjust - Flywheel Removal - Stator Charging Issue

In This video we are adjusting the clutch & removing the flywheel on a 2004 Yamaha Vstar 1100 Motorcycle.
2nd of 4 tear down videos:
• Yamaha VStar V Star 11...
Also for more common service/repair Yamaha Vstar videos check out:
• How To Adjust Valves -...
• Yamaha VStar V Star 11...
• Yamaha VStar V Star 11...
Patreon / midnebraskamotorsports
Instagram / midnebraskamotorsports
Check out my eBay store at stores.ebay.com/midnebraskamotorsports
We Disassemble: Clutch Head Cover Cylinder Piston Stator Points Rotor Magneto Generator Alternator Coil Camshaft Cam Chain Tensioner Rocker Electrical Cases Bottom End Case Set Transmission Shift Drum Fork Gear Shaft Flywheel Starter Idler Clutches Bearings U Joint Yoke Driveshaft Shaft Float Main Jet Bowl Slide Needle Seat Intake and more Assembly

[@keeganohare4546]

great video. what's manufacturer/pn of the puller kit you are using?

[@buddyharshaw9140]

Good video thxs,I had a ? I have 1100 vstar just replaced the voltage regulator and I noticed there’s a blue end plug not plug into anything do u kno what that plug is for?

[@buddyharshaw9140]

I subscribed thxs,the blue wire is just hanging bye the regulator not plugged to anything

[@buddyharshaw9140]

Hi had ? Again on the negative side of my battery box there’s a 4 prong relay I seen on eBay it shows it’s a safety relay but it has a bobble on it from burning out and now the speedo don’t work an the blinkers dim all lights when on do u kno the purpose of this relay?

[@r3ckl3ss_snip3r2]

I have a 2000 Yamaha VStar 1100 Classic. Solenoid, clean carbs, regulator, sparks, O ring and new battery was replaced a year ago wasn't kicking over. I recently got a new battery and it's dying so fast and still doesn't want kick over. NEED HELP

[@samuelmiller9813]

Is there a put together part for this? I took the cover off to change the stator and the idler gear fell nd I can’t get it back into place for I need to take the starter clutch off in order to get it back on?

[@dalokz]

Take off the cog on the starter motor. You will need a pair of snap ring pliers. Take cog off, put idler gear on first then put starter cog back on.