Рет қаралды 4,399
How to sync YN560III to YN560 TX manual controller:
Step 1: Ensure Speedlight is in "rf603' mode. Press first two buttons on the left (FN) to get into options menu. Scroll until you see "rf" options and toggle to 603.
Step 2: Ensure speedlight is in RX slave mode. To do this press 3rd button until it cycles thru from manual thru s1 and s2 modes to RX slave mode. Once here, the speedlight and TX can now communicate to each other
Step 3: Turn on your TX manual controller. (At this point both devices should be powered on). On the TX, press the last two buttons (far right) buttons at the same time. This should result in all of your speedlight LCD options lighting up at the same time. While the screen looks "jumbled" you MUST then press the circle button in between the navigation buttons on the speedlight. When done correctly, the 'group" function on your speedlight will NOW be enabled.
Note: If you do not press the circle button within the time frame of all the options on the LCD of the speedlight being highlighted, you will have to repeat Step 3 but do it faster.
This is my first tutorial video so I hope it was clear and helpful.