Z120 with 212cc engine

[@TheRealKalEll]

YA bro...do an updated vid. Lots of us love these little superbikes, sleds, dirtbikes, boats, etc, LOL. Keep up the good work

[@Tristandow74]

I ran 22 mph on ice with configured stock pipe and stock gearing in 660 feet

[@TheRealKalEll]

Add a used turbo from anything on Kijiji

[@chadly327]

I should do a updated video it now has alot of custom mods the motor is putting out about 12 hp now

[@wo8795]

@@chadly327 can you make a video how it rips with 12hp

[@TheRealKalEll]

AWESOME BUDDY, AWESOME

[@bumblebee82010]

andrew gates there are going to be new videos put up about doing mods!

[@TheRealKalEll]

Can't wait to see em

[@owene3270]

Could you make a video rebuilding this machine or even taking out the engine and putting it back in? I am looking for a small “for parts” snowmobile to do this for my self.

[@chadly327]

I can do a video like that i hace to do some work on the motor anyway

[@owene3270]

ohh thanks! Did you buy the snowsled used and with a blown engine? and what do you think topspeed would be with someone weighing about 160 pounds?

[@chadly327]

I did get it used but the old motor didnt have much power so i upgraded it and it depends on what gear you run i started out with 12 front and 35 rear it was a power house with not much speed im running a 14 or 15 front now and a 40 rear slower takeoff better speed haven't cjecked the speed with this gear combo i weigh almost 200 and it goes good with me on it

[@owene3270]

Okay thanks

[@nicholastrevena8814]

Do you remember what size bit you went with?

[@nicholastrevena8814]

I did the same swap in my kids Polaris 120. I had to do the same thing you did with the intake. My question is did you have to rejet the carb? The one we have dies a lot especially if you punch it. Like it's getting too much air.

[@chadly327]

Nicholas Trevena i did end up drilling the jet. I got some mini bits from napa and started small and went bigger until it just started running rich.

[@nicholastrevena8814]

Thank you

[@chadly327]

Nicholas Trevena i dont remember what size it was because i have done to much carb work i bored and jetted the crap out of it now so its hard to remember where i started but you dont have to open it up much to make a difference

[@dawsonbulger4529]

How fast she go

[@chadly327]

Hopefully I can do some videos this yr I've got a lot of stuff to do to it

[@plowmaster1206]

What is the clutch?

[@chadly327]

It's a hilliard clutch you can get them at tractor supply or online in any go kart supply

[@plowmaster1206]

chadly327 thanks for the quick reply! The reason I ask is I got a sled without the motor or the clutch...so I have no clue which clutch fits this Harbor freight motor

[@chadly327]

I have done a lot of work on this sled since this video was posted I got a lot of parts from rec motorsports and nr racing you should check out their Web sites