Everytime I switch the printer back in I have to rerun the configure printer settings area to get the label printing correctly again (I change the settings from default). Is there a way to make the printer not resort to default label settings each time?
@symmoto4 ай бұрын
You should try the Zebra help desk. Once the settings are configured in the ZSU, they should remain set. The label data can contain code that can change the configuration, but maybe there is something else doing it as well.
@Youngl3lood32 жыл бұрын
My problem with my ZQ520 is that my media settings don’t save my 3:2. It keeps going back to 4:2 when I turn it back on
@symmoto2 жыл бұрын
If you are referring to the label size, maybe set it to defaults and then run a calibration. Defaults: ! U1 setvar "device.restore_defaults" "all" ! U1 do "device.reset" "" Calibrate: ~jc
@SportsLife247 Жыл бұрын
Does anyone know how to stop a print once it started?
@flames3168 ай бұрын
how do I print the ip address as a scannable label?
@symmoto8 ай бұрын
I am not sure. You can reach out to the Zebra helpdesk at 800-653-5350, or check the developer zone.