Maybe i should subscribe ( I race my car so i know i will be needing alot of tips on Replacing and fixing parts

Thanks to you man. I was able to Replace my rack and pinion on my 2003 volkswagon jetta gls. ( Same exact Layout as this car you did ) and i got to say. I give you props.

What about the cold start cable?

The wiring looks a mess 😂

What size tyres are these? :)

I've is the spline bit for the cv joints ?

It was going so well, what happened man?

Nice job on that one! What radiator are you using?

Hey have you ever run into any timing belt tracking issues after replacement? Mine keeps tracking towards the diesel pump when I turn the engine over a few times.

Imma need you to work on mine for me 😂😂

I’m at this stage and was wondering how you get those bits that curve in. I saw one bloke just cut before the seem which was smart.

Good video, thanks

Yeah, good luck finding a clutch or a fly wheel for a one. I’ve been looking for two years I have an 82 Toyota diesel.

haha I have the same problem, someone covered my entire dog leg with bondo 1/2" thick. Tip heat the bondo with a heat gun and peel it off, no dust.

Back light chahy kha se mile gii

Fantastic video thanks so much.

Great job!!!

Nice truck. I just recently found your channel. Watching your VW bus vids

👍

👍

Great repair !!!

Very nice work. Digging the bending tool !

Nice fit! I'm digging your content

Nice work.

Just found your channel. I just picked up a 69 bay window. Needs alot of work

Great detail right up on this video. Is it possible just to remove the back portion of the subframe and leave the front still connected as long as it supported to get the steering rack out?

Thanks for the awesome video man ! Just a quick question, how do you make sure that all the air is out of the system?

Did you bother to ensure the rack and pinion was at center before installing. May have oversteering to one side

Great video! I'm about to embark on the same rack and same car, will follow your video as a guide.

Excuse me, I just wanted to know if you can help me with my car. I have a problem with the power steering. It spills all the oil. Can you help me? I removed the old steering and put a new one on, but I don't know how the connection is going.

Hi Steve great video thanks for sharing. I would like to know how you installed the computer and if you had to buy a special harness or did you use the same harness from the donor car? I am about to convert my 1970 VW bus but I am collecting information to be able to do it.

Excellent video thank you very much for sharing. Does the heating channel have to be cut to be able to install the radiator?

I might try this on f150

Yeah I've done this that s*** don't last nothing it'll also jam up your f****** latch so get the real s*** how about that

Black electrical tape works good too

Should’ve bought a Ford! Doors close with a twitch of the rist

Yeah for about 30 days

great channel! HELLOOOOO

Finally no more kathinkkkk

Stop slamming your door. If people greased and oiled their door mechanisms they would shut like butter

Wow it takes less time to just fix it .

After four slams it needs a another replacement. Fix it properly

CorvairWild would use electrical tape.

A people like you I really appreciate each and every single bit of your time ❤

Look at the line on the door. The door needs lifted up. Hinges need adjusted or replaced.

I need some of that for my '99 two door two wheel tahoe.

Nice GMC bud And nice song

Naw

I can't wait to try this! 😂

Huh I guess that pex shit I'd good for something