What did you look up on Amazon to get that piece

literal life saver ty so much i was dealing with the same problem

Have you had any issues with the fasteners becoming loose or wearing out from off roading or the weight of anything hanging off the rack, i.e. awning Thanks.

Where did you order the part you added and how much did it cost?

Thank you so much.. I have a 2002 honda crv and it did the same thing. Checked out your vid and it was that. I saw plastic parts on my floor mat. I put a piece of cardboard with tape until I stop by autozone to pick up the part.

My man I thought it had something to do with the break peddle and checked that before your video but didn't realize it needed that plastic there and what do you know I found that plastic your talking about! Thank you so much your the fucking man!

This is next level. Absolutely awesome!

Great idea! I need to build one!

Same situation here...I was headed to work, came out to start up truck, and had no power... ok I thought, get my battery pack charger and charge my battery. Didnt notice my brake lights were on until it became dark outside... Then I scratced my hea s puzzled to what waa was going on. Checked fuses like one would do first, all checked out... Searched out youtube and saw your video... I laughed so hard when you mentioned the little green plastic pieces... Thats exaclty what I saw on my floor board the afternoon before.... I thought it was something I stepped in and didnt think twice about it..... I piked up the pieces and threw them away.... Now I know.... I feel excited now.... Thanks for your video Sir....

Great video. Just an fyi depending on your car the piece could be a clear rubber, my Acura TLX was.

Very useful. Thank you....

I literally paused the video at 2 mins looked at my floorboard and there's that same piece snapped right in half under my pedal 💀

I have a 2005 Sequoia This was the problem on my car, there were 2 brake stop pads I replaced both Lights Off

Earned a sub👍👍👍

Mine is rattling as well, from the same place, i got a outlander 2020 with 90 hours on the clock. That shit is embarresing for Can Am. Wonder if the fact that it is made in Mexico has anything to do with it. Surley they must test theese before they are shipped out. I noticed on a few forums that they sound like this brand new. Thx for the info, ill check the spring tomorrow.

If the plastic is there then you can't do this.. so I'm guessing this is after you have gotten it open . Or fixed

Where did you get that latch? The link does not work.

Went to my floor board and yes saw the green plastic buttons broke great vid thank you

Anyone know what the bolts he used to connect the bars are called ?

Thanks I wish I would have seen this earlier. On my 3 fucking time repairing this door latch. So frustrating. This is awesome!

Thanks for the video

Awesome build, where did you get those fasteners?

Fellow Utahn here ✌️ About a week ago, I just picked up a 2005 SR5 sequoia. Loving it so far and I have some plans for it. It's already equipped with front and back upgraded suspension and rear springs. Front struts. Changed ball joints. changed timing belt. Cool vid cool rig 👌

This is awesome! Can I get this part or do I have to make it?

When seen that in the floor bord I thought someone been eating candy in my car and it was green lol but now I know what it was thanks for the info

OEM Latches are NLE

This is a common problem on Hondas and Toyotas

I have two lithium batteries on my trailer and I mounted them under the bed up by the side of the hot water heater so I can store my trailer hitch and load bars up on the tongue where the batteries originally were

I also searched for fuse to shut off my brake lights and found this video and sure enough I found the broken plastic grommet. Thank you for posting this great trouble shooting video.

Bro. You made my day. I wish I could venmo you some $$ and buy you lunch. Thank you!

I think I missed something, why are you including the cable with the install of the bypass? So that you can open from the inside? I am thinknig about getting this but I prefer not to install the cable

same here with rear door latch. i got the amazon metal one and the arm that pulls the cable bent. i took it out and slightly over bent it back, and fastened the cable more securely to the door panel to get a little stronger pulling angle. have been gentle with it and its been working great.

Thank you so much this was also the problem with my car but instead of the rubber falling off , the little switch has dug a hole thru the rubber making it not press down!

Thanks you and yes my issue ... easy fix except im in the philippines so had to make the part myself ... easy job though

Thank you so much - this was my problem as well!!!

Thank you

Saw the broken pieces on my floorboard this morning and thought it was broken candy , wow very helpful headed out to purchase the piece!

I actually searched for where I can find my break light fuse, to turn off the light, instead I found this. This is the real, unerline issue I had. Thank you bro!

Cracked me up when I looked at the floorboard and see the broken pieces of green plastic. Thank you so much.

Can you send me the link?

This was so helpful. I fixed the problem. Here is another tip for those with the same problem - get a 'flip flop' and cut of the stopper from the underside. This stopper is exactly the right size. Strangely enough, I had cut one off only yesterday, so I took it to the car and it fit. So if you don't have the part, use that bit from the flip flop until you can get to a garage. 😘

5⭐️ video! Excellent information. Went to local auto parts store and installed in less than 2 minutes.

Thank you. Just went to my truck to check it out, and I immediately saw the green plastic pieces on the floor mat.

Asking for trouble mixing carbon steel brackets with aluminum. Painted or not they will start corroding. Should have used stainless for the brackets.

Much love 🎉

I'm assuming it doesn't work without removing the plastic piece first?

Whered you get the strip and how much was it??

Thanks. I fix my car after two days unplugging the battery every time i use it

Very expensive and out of sight, kinda dangerous. I actually like the generic one you had up there more

Sheeesh, thank you for the info. My rear lights were stuck on today and I looked down on the car mat and there was my issue. The piece broke off, easy fix. I’m glad we got KZbinrs like you. 🙏