So you didnt flush it out with distilled water? You just drained the old coolant and added new coolant ?

Looks great! Not sure I can do it myself though

@1buildmedia what the brightest HID bulbs is the best for this car am in jamaica

Yikes, not using Nissan blue? good luck with that

Is it more powerful then the factory radio

if i buy the halo kit does it come with all four halos or do i have to get multiple quanitity's

This is by far been the most helpful install video for these screens. I was able to get my camera working with the re-pin, appreciate that info. However, I am still having the following two issues and wondering if you ran into the same things: Car info: 2010 G37 Sedan with Bose and No navigation (similar to yours I believe), Radio info: Rhino PX6 13.6" Android 9 screen (looks to match yours exactly) All functions work (BOSE sound, backup camera, carplay/ZLink, wired carplay connection, hazard lights, passenger airbag light) except I'm having the following issues. 1. My AC controls don't work however the auto-blower turns on when I start the car. I just have no control over them. I'm using the same plug that you recommended for yours and the A/C controls show lit up like they are working but neither the buttons or on-screen controls work. I believe I tried the other plug from the main harness and got no A/C blowing upon start up so I don't believe it's that one. I can almost live with this since the auto-blower does a good job of matching the temp inside the car but would be nice to have. I already did a lot of troubleshooting with the "Install set" and making sure it is set to QX70 (matches my CANBUS), Protocal Tangdu and G37 car type. I have tried a few of the other options but they haven't worked either. 2. If my car sits for longer than a few hours after driving, I have to jump it to start it, like the screen is leeching battery. I have gotten an alternator test, changed out batteries, and replugged the harness in but no luck - always seems to drain it down. The screen appears to shut off completely when the car is turned off and I did not have this issue when I swapped back to OEM radio for a few days. Any suggestions? I had a Px3 for a few years and wired in a step-down to get the factory camera working on that harness so I have a general idea of what I'm doing but have not had any luck with this PX6 and fixing these last 2 issues. If you didn't run into them, perhaps it's my harness but Rhino has not been very helpful and only send screenshots I've already seen from their troubleshooting guides. I wanted to check with you before I tried splicing into any wires or requesting a new harness from them. Thanks again for your walkthrough, as I mentioned before this has been the most concise and accurate guide to getting the PX6 radio (at least the on I have) installed correctly.

How long was shipping on this ?

How do you get the big red piece back on after you cut it out.

I'm so late. Just installed mine today, haha.

Hey got a question, currently working on a project doing the quad halo set up. I have the red halos going from black>to black Red> green , white> green and white And i have the switchback halos yellow> green with yellow and i have the black fused with the black from the red halos both going into the black from the oem harness. However when i brake the ambers turn on instead of the red. Any idea why? I only have black and yellow going to the harness.

At 1:45, what is the inner diameter of that hose? I need to replace that part

You know you didn’t have too use a dremal you could of used a heat gun too take them apart

what year is this car in the video?

nice , how is it holding up ?

So the diode dynamic turn and tail won’t work for halos ?

If I wanted to hear loud music I would go to a concert. Turn the music down so I can I interpret the accent😡😡

Did you reinstall the plastic piece that holds the ballast/ignitor cable ?

Could you not wire the halos directly to the circuit board?

Bro I need your help putting n my screen before I burn it up

To glue the LED strips can you use hot silicone? I would like do it with halo and RGB trips… yours lights are fireeee🔥🔥🔥🤙🏾

Did you use 110 or 120 mm

Hey this was a good video but im hella confused on the wiring part and how you got the angel eyes to light up after you put them back onto the car any advice or tips

i have a 2008 is it the same steps?

is it easy to take the trunk reflectors off too and spray those black? I dont like the mismatch

Did you bleed all four brakes ?

Do you leave the car on during the whole process ?

Did u have to install new camera for the back up camera or is there a connector u can plug in with the stock one?

Has anyone tried this on the convertible? Do the same parts apply?

Could you use a heat gun to remove the lens?

Am I allowed to have these purple lights on my infiniti in California?

Your video needs more recognition for helping us all out! I have the coupe so the steps were pretty similar thank you!

What drill size u use

Did u have any issues with the sound it doesn’t sound as loud as it did with the original rsdio

How much coolant did you end up filling it back up with? Including the reservoir tank.

I see u have 2 front lips and I wanted to know what’s the first one

Had to subscribe because I appreciate the time you took to make it this easy for us !! Can’t wait to get mine

I have a g35 I want to change the radio but I don’t know which radio I can buy, please help me with that information

Can anybody guide me on the right direction, I recently changed my thermostat and radiator After symptoms of overheating, I cannot be on drive-through or any place stop for more than 5 to 10 minutes when temperature will go high seem to work fine for the first two weeks has been a month now, and the symptom is back as far as parking for more than five minutes and starting to heat up, so I figured I will replace the thermostat one more time which I did, and wanted a good tutorial on how to change the coolant which led me to this video, I also ordered the funnel on Amazon used it today, but I noticed that it wouldn’t stop fluid from going to the reservoir, my other issue I had was trying to put my AC in hot, it would not heat upat all, it will throw fresh air after having it on for 10 minutes. Car started overheating, what should I change next?

Hi what size the angle eyes are ?

I was wondering what kind of coupler or heater hose you use or got it from? I had the same issue also where my coolant just steamed everywhere. Was thinking of doing your way?

Can I pay you to install my

Is that a Trini accent?

Car looks really good! I know this location

😍 I need this 😩

how does it affect camber for wheel tuck?

I’m trying to get a backup camera will I be able to swap this one for a nav one ?

What’s the fuse tap you ordered on Amazon can I get a link ?

You’re amazing thanks a bunch and hope all is well!

Hey the only thing i seen you missed/ skipped past in this video is how you did the wiring for the halos. once everything was sealed together what wires did u splice into. wiring management ect. if you can provide that it would be great