Only weird thing I see is lots of other people put the top of the boot over a shingle. You put the top of the boot over the underlayment. Does that really matter? Are there any building codes to reference on boot installation and layering over tiles?

You said exactly what i was thinking.... Now these 2 courses are basically glued together and not independent of each other. I would be concerned with contraction and expansion issues with the 2?

I have not seen anyone else show it like this excelent teaching

Nice video🎉

Are you doing good job shoring roof you do good job

Your starters are on wrong.

Cottonwood

Does not look so good , rusty metal will not last as long as the roof. Wait a 30 year roof only last 15-20 perhaps it will unless there are other mistakes and omissions to cut the roof life short .

Pay payroll taxes each week have accountant do quarterly tax reports spare money for people that won’t pay the rent there are a lot of them bad economy dump in the owners yard to get containers-- law suit IRS laws to comply with also good luck

You Know it's screwed when you see the biggest no no of roofing on the thumbnail

You should nail your step flashings higher

Shingle Tins = Step flashing. For those wondering.

I cannot to what you do

Looks hard. I may have to..use. seal tar seal stop leaking.

This guy is absolutey not a Pro. Never caulk the bottom

4 wraps is good bro

You used a pencil on unprotected aluminum!? That's so wrong, nobody told you what that does over time. The pencil is going to each through the aluminum. It's wise not to use pencil even on painted aluminum because paint layers are so thin the ions still transfer through to the metal. Glad that's not my fascia work.

No new video..am Dave from Charlotte nc chin junk removal and dumpster rental..I always watching your videos

Perfect video - your approach is rock solid. Do you have any idea on how to do step flashing on a sidewall that has existing STUCCO on it? Just can't figure out a great way to make it water tight - not even sure if you can grind a thin channel into it and put in some counter flashing into the groove...

Do you not need step flashing all way down? Or was there step flashing further down?

A true teacher.

Nice repair, also recommend leaving a water channel at all pipes& step flashings so dirt will flow down and not dam in future.

Bro am I smokin crack or do u have ur valley started backwards . I was taught to weave in bottom 2 rows. Then run ur lowest pitch roof , smaller roof , then run ur cut side , bigger steeper roof last

Start like you always do, off the left side so you can use the gun to gauge and staple like no tomorrow. When you get to the valley just cut material so you are about one and a half to two tabs away from valley. Keep slot out of valley.

Can this repair be done if it’s raining? Would you recommend postponing it until the rain stops?

Is that hoist from Nedlands or did it come with the truck?

Thanks for the information about Dockett

I have a 20 foot landscaping trailer and when I have to do that and even when I stop by the curb to service a yard is to put out safety cones . Just my dos pfennigs for today. PROBST!

Would water get in the pipe?

Good job 👏

I'ma send you a new caulking gun 😂 good work tho

Do NOT leave your nails or screws that loose . Bad advice

A dy

This is exactly the issue with my roof! Thank you so so much!

So this video is 2 years old and ya mentioned that you increased the rate to $400 . Well today’s December 17 , 2024 and how much is your 15 yard dump fee ? I have a 20’x6 x4 landscaping trailer w steel expanded metal walls & it’s not a dump trailer but I’d like to see what ya think would be a reasonable and profitable rate to charge ? I live in San Antonio and I also own my Duramax truck and the trailer.

Quick question does the Nedland trails can handle a 25yd?

You can shinglethe bottom of that flashing right in like you're going over plywood it doesn't matter I don't play that game I've never left the bottom exposed never had a leak

Subscribed! Easily the best roofing video I've seen! Shoutout from a fellow Midwesterner

Quick question what model gun and nails did you use for this Job if you dont mind me asking ?

Great video 👍

Keep up the good work great video 👍

dude looks like brent hinds

when should you use metal flashing for valley?

👍

Longer nails required if there are several layers of shingles. Adjust length of nails as per job. Cheers beers 🍻

The volume on this video is either wayyyyy tooo quiet or I am "Special"

What are they charging you today?

I love these metal roofs but rust on the screws and rubber washers which will get hard and leak in time is always scary imagine several leaking at the one time. THERE SHOULED BE A WARNING ALL SCREWS REPLACED AFTER A CERTAIN LENGTH OF TIME V / G VIDEO😊😊😊

Brother theres many problems with tht install that underlayment should be ice and water due to the pitch the pioe boot should have ice n water on top of it and the shingle above it shoukd have a groove cut into it only leaving a 1/4 inch gap around the boot those top corners on that boot is way to exposed

what was the reason you didnt put ice/water shield all the way to the top I think I missed you explaining that