Really what model inficon?

@@D2DNYAC the Stratus. I started with the field piece but got frustrated with its self zeroing function really fast. I'm in commercial/rack refrigeration so getting beep beep beep while standing in middle of rows of coolers with 2 dozen or more evaps is very not helpful. Especially when it "zeros" itself and you lose the trail because chasing the breeze.

@@Jonathan-hx6oystratus better than the h-10 pro?

@@Mudo94 i can't say i haven't used h-10 as far as i know

@@Mudo94 H10 is the best heated diode refrigerant leak detecter on the market, it's main downside is the high cost of part replacement and lack of that flexible neck

If the pilot doesn’t get ignited the main valve won’t open and the pilot indicator light will stay off and the controller goes into alarm

@@D2DNYAC We had an issue where the "butterfly" was staying open and blowing out the pilot when we initiated the main valve. I didn't really fix the issue, I just dial down the temp on start up, that butterfly closes to "idle" and then I can start it. We use Honeywell controllers and were getting code 19 and I think it was 17 both a flame out iirc. The ovens we use are old, 1989 on the plate. Prior to working where I do now, I only had basic home experience. I've been watching a few of you content creators on YT and want to thank you for your channel. It really has helped me with diagnosing issues. Edit: the controller we use is the exact one in the video.

To get up and going solo I would say 1 to 2 years however you never stop learning my friend

Dimple?

@@D2DNYAC the 3rd partially drilled hole on the locking collar.

Where are you located?

Nope

The fan is spinning backwards because of air pulling through by the fan that's running and this fan is bad

Yes and yes

Thanks for watching

Leak lock seals the threads

Very nice

How are you liking them so far? I’m considering getting them or the fieldpeice smans

you have to go into setup a d set which remote temp sensor to use for control or averaging

You can move them from thermostat to thermostat just disconnect device then do the link process for each sensor

Buy it online

@@D2DNYAC have any link this not getting online

Thanks for watching

This isn't a chiller

Thanks for sharing

Ooh yeah

By the rotary dial switches

😂

Okay thanks look out the video

😂

Thanks for watching

Schooling

Or diy to a certain extent

Yes

Okay stay tuned I will upload a video on that

Thanks for watching

Check contactor coils and liquid line solenoids coils

Wow. You’re the best! I don’t have words to thank you. It was the solenoid valve coil that was causing the short. I really appreciate your help.

😂😂 I feel your pain brother

M J foxed ?

Not a bad idea

Definitely

Thanks for watching

Nope

Yes Rs485 to usb

Thanks for stopping by

Like and share

Definitely 😂

Like and share

Thank you for stopping by

Like and share

Really , how do you feel about Brunt’s?

@D2DNYAC I've never had a pair, but they're cheap. I'll stick with my Keens. Next pair, I might get Thorogoods.

@D2DNYAC I also should say, that my last pair of Timberland pros were purchased off of Amazon, so they might have been cheap knockoffs. 🤷‍♂️

I don’t understand what you are asking my friend

None heatpump is correct? Heating is provided by condenser water, while the well water provides a constant heat load for the evaporator

I did lots of work on one practically brought it back to life 12 modules 24 circuits , which is really an amazing piece of engineering