1.5 Mazda 2 Coolant Change and Thermostat Replacement

[@doit_vehicles]

Oil Change on Mazda 2 : kzbin.info/www/bejne/imSQYnR9aq6bhtk

[@iNFECTED_pIE]

Thanks, this gave me the confidence to replace my own coolant.

[@jcjc4164]

How old was the coolant before being changed? I've seen some Mazdas have a suggested first coolant change interval scheduled at 10 years.

[@liammorris7846]

Just an FYI the blue light that comes on isn't for low coolant, it's for coolant that is cold

[@1BYEBYE1]

Thought I was fucked and had to replace the coolant level sensor too, don't think this car has one.

[@4blok]

Excellent videos! Thanks for sharing your knowledge! Best regards from Serbia.

[@doit_vehicles]

👋

[@joelwatling4421]

Which way is it meant to sit in the housing? Is it with the spring towards the back of the car or the front?

[@alexandrosaravidis9432]

👍👍.. Can you make a video where you can show us how to take out the intake manifold

[@CROFTY71]

Hey brother good video. I just wanted to know there is another 3 bolt water neck housing. Right hand side of engine just across from the battery. What is the name of that water neck housing. 🤪🇦🇺

[@guapora]

Hello, I have a Mazda 2 1.3Lt FROM 2009 and every day when I start the engine it gets cold, the engine shakes enormously for the first 15 minutes then the engine runs normally, later the engine actually runs at low speed. I have already replaced the spark plugs, replaced the throttle body, cleaned the air mass sensor, changed the valve oil control sensor, air filter, cleaned and checked the injector nozzles. The car has 181,457km on it, I also cleaned the oxygen sensor and nothing. I don't know if they will be PCV or EGR valves. I don't know what any help would be helpful. Thanks

[@Pedro15SK]

Thanks for your fantastic video, i made the same this weekend, thanks for your help, and excuse me for my English

[@agenorzc]

Thank you so much. God bless you! Where are you from brother? Nice strong accent!

[@vincentnaidu4658]

please tell me the reason you change thermostat

[@alexanderjaramilloimita]

hello from colombia, I think that the thermostat of mazda 2, 2008, this is incorrect. could you tell me, what is the reference temperature written and marked inside the thermostat housing. my thermostat has "82° C" written on it

[@vladimirsamelo8366]

What is the cause if the water coolant comes out in the reservoir if the tempwrature is in 3 fourth in the temperature gauge

[@redbustourguide]

How much coolant needed? Mines not sky active

[@steve75112]

surely there has to be another way of doing the thermostat than taking the manifold off?

[@wasp91]

if possible, make a video on replacing the thermostat mb w176 m270)))

[@davidsinetar9047]

wher is the cooling fan switch

[@alejandrolinares7308]

More videos of mazda 2 2011-2015 and more years

[@ItsDavidCreator]

How did you remove the thermostat ?

[@007mechanic7]

I only had to remove alternator to get to the thermostat easily accessible

[@leviward5494]

Hey bro how did you remove alternator

[@joelwatling4421]

For the thermostat which direction is it meant to sit in the housing? Mine poped out as I removed it so idk how to place the new one

[@louieanderson2847]

Where are you from? Nice strong accent.

[@markezekielabedes1502]

May I know what year model is that?

[@doit_vehicles]

2013 , sorry for latereply

[@josecabello-pb7kc]

Bien exelente

[@ayhanmutlu5722]

W210 cdi

[@kashmir4409]

How to remove drive shaft drivers side.