GoPed, HOW TO: Rear Wheel Set Up, Chain Set Up and Sizing GSR46

Subscribe HERE!
/ @123derekshort
LIKE me on Facebook…
www.facebook.c...
FOLLOW me on Instagram…
www.instagram....

[@earlebird4262]

You're a true expert. Thank you.

[@littlepat]

thanks man!! swapping a 46 onto my 29cruiser soon!

[@wwm8526]

Nice Nsr 😊😊😘😘

[@chuckennuggett]

My snapped and im trying to figure out the size. My original chain was pretty loose but tight with chain tensioner.

[@Mr_rite_now247]

I have a gp260 goped riot, it’s stick, I want more torque how do I do that???

[@sonnyhurt84]

How far do you screw in the chain tensioner bolt

[@matthewgilbert1765]

Hey I have a question about card and pipe tuning

[@AngelSanchez-wq6gt]

Wats the best motor for the grs40 u can recommend

[@loadthebowl]

Do you have to pull the motor to change the spindel?

[@andyman123able]

Can you give me the dimensions to that platform you have your go-ped on? I want to fabricate one for when I work on my go-ped

[@jefferwin9160]

hello derek i am new to this and i got my first gsr46, so my question is do i have to take the motor off to change the small sprocket and and chain length

[@BluPhire86]

No sir

[@davescheer5038]

Derek I just got a second hand super razor 3V it's got a 43cc motor I'm having a problem with it it idles but when you give it throttle it cuts out ? Any help would be appreciated .

[@Ollieofwrexham]

I have a question, should I align the wheel sprocket to the engine sprocket and use jus 1 chain or do I have some sort of safety setup in case of failure? Cheers!

[@MikeHunt2053]

Where ya get the chain breaker at? Thanks for allll the videos... Building a GSR cruiser for the grist time...venturing from spindle drive!

[@123DerekShort]

chain breaker can be found at davesmotors or I think adaracing might have 1...

[@trppen37]

Derek Short Yea I just missed buying the chain breaker a few hours ago while it was on sale... either way I need one... thanks on the other videos!

[@queavogold3986]

Thank u,good tips..

[@oliviaash6700]

Hi Derek, Did you build that goped stand yourself? I am looking to purchase or DIY one myself and curious how you did it . Thanks.

[@LivelyguyOR]

Yo Derek I'm running GP460 with dom pipe what teeth setup is for top end? I was thinking a 8/64 what you think?

[@JayPlays792]

Hey Derek what size is that bolt

[@CrazyForCooCooPuffs]

Thank you, these videos are very helpful, getting closer to the gxh50 swap on my gsr46r