12v electric automotive ac compressor

Рет қаралды 28,695

Жыл бұрын

Пікірлер: 30

@user-xp1gj9hq7i 7 ай бұрын

I have one almost like yours how much ester oil do you add and I only have the block where the smaller wires are on the compressor and the large you have going to your power block are on the compressor and I got no instructions with this kit and no response from the company

@Driftprodigy01 9 күн бұрын

How is the system does it cool good i currently have a weekend car that doesnt have ac because my exhaust runs through the same location front facing headers and dont have ac compressor room

@topher8634 10 ай бұрын

In HVAC usually HX means heat exchanger. TX usually means transmit. The motor should be located on the suction side of the compressor as the cool gas coming back is what cools the motor. I believe these have a evaporator that comes with them too that is fed from the control module. Both the condenser and evaporator are heat exchangers; one picks up heat and the other rejects it.

@vivek.ananth 3 ай бұрын

I’m looking to do this, was it possible on your end?

@abosaraabosara7544 25 күн бұрын

اسباب توقف الكمبريسر في الاجواء الحارة هل هو خلل في الكهرباء ام في الضاغط

@felipefarfan2380 11 күн бұрын

a question. I have the same compressor and my question is the cables that come out from inside the compressor, where do they connect? thank you very much for your video.

@mahmoodjani1371 20 сағат бұрын

Sir who much pres only compreser and kit tell me sir

@jonathanhermis1929 Ай бұрын

I have two of these systems... My green wire is ran from the controller through the pressure switch to the trigger wire from my evaporator... That yellow wire does nothing.... The ones I have purchased have a safety link from the controller to the compressor.. Some have these and some don't... However I can tell you from using these its only going to put out 20 degrees difference from ambient temp.. If its 100 degrees Fahrenheit outside the best it will put out is 80 degrees.. And how much freon you put into these compressors is a mystery.. I have 3 12 ounce cans in mine and low side is around 60PSI and High Side around 140PSI... I try to follow the standard chart for R-134a and its never correct... Maybe someone can tell me how to get these systems to cool better.

@AutoMotoMechanic 22 күн бұрын

Try it around 35lbs on low side. Keep great air flow across condensor

@AutoMotoMechanic 22 күн бұрын

If you're plumbed right back in factory condesor and evaporator etc then the refrigerant capacity should be roughly the same

@donaldperry148 2 ай бұрын

So this compressor is universal and be connected to any condenser and evaporator

@odd13579 Ай бұрын

That's their claim. They make different capacities tho, don't know how to decide whether to use the 22CC or 26CC variant. On Amazon, the 22CC variant is $350 and the 26CC variant is $399 (right now, anyway).

@mikekimble6084 Ай бұрын

Like that lip smackin

@jacobaudi81 10 ай бұрын

How much oil you put in the system

@Viajandoa80 6 ай бұрын

El aceite ya viene en el compresor y gas hay que poner sobre 800 gr

@sshyshy6097 3 ай бұрын

did you ever find it out?

@TeddyZues 3 ай бұрын

Yes I am just starting to use the system again and it is working well. I will be making a final video on this shortly. I am running a 160AMP alternator out of a 2001 5.9L Dodge Durango, I have upgraded the charging cable from 6AWG to 2AWG as well as the cable running to the second battery which is out of a 2001 Ford Explorer. There is a 250AMP diode between the 2 batteries and a battery isolator to prevent overcharging and alternator damage. With this set up I have been able to run the system continuously without damage for a month now. The last step is to get some hoses made because mine are leaking, go figure.