'19-'23 Ford Ranger 2.3L MBRP 3" Cat-Back, Dual Split Rear Exit Exhaust w Black Tips Part S5223BLK

[@ctvxl]

I have the Roush cat back system on my 21 Tremor. I like it the best. Nice and compact, sounds good, but not too loud and zero drone.

[@quickiereviews1428]

Right on!

[@ericd4610]

Had to drop that tire so my huge ass would fit in there 🤣

[@quickiereviews1428]

I appreciate the helps! :D You ain't done tho, son! haha

[@tonygiordano939]

Did you have any issues with the drivers side pipe coming to close to the brake line? Did you zip tie the brake line away from the pipe or use some type of heat wrap or just left it be? My brake line is about an inch from the pipe, wondering if that’s normal and ok. Thanks

[@quickiereviews1428]

No zip ties were involved in the assembly :)

[@stevelane5023]

This system is the one I decided to go with. Not to loud, looks good, and no drone. Watched every video I could find on exhaust systems for 2022 Ranger and all have said that there is no drone on highway. Biggest selling point for me. On another note the tires you are riding on. BF Goodrich makes a great all terrain tire. I have used them on my past 7 trucks. Low road noise, good for light off road and snow, and great wear. What size are your tires? Any issue with rub at full lock? Once my factory tires are done the old trusty BFGs will be installed. Thank you for your helpful information.

[@quickiereviews1428]

The tires are 33's - no rubbing, but it's also a 5" lift with the front crash bars removed. I made friends with a guy that has the same truck but in white & his came with 35's. I didn't ask him though if they rub.

[@stevelane5023]

Thanks for the info. Truck looks great. My truck is a 22 Lariat I had purchased used with 3,000 miles. Just starting to make it my own starting with exhaust. Good luck on any future upgrades.

[@veedeeiot]

did you wind up with the passenger side hanging lower than the driver? i have the same exhaust just not blacked out on my 21 and ran into that issue. tried heating with a propane torch to bend and that didn't help either. gonna take it to a shop and have them do it.

[@quickiereviews1428]

Hmmm maybe a little - right side was touching the bumper. But all I did was crawl back underneath, loosen it up, adjust it, and tighten it back down

[@veedeeiot]

@@quickiereviews1428 my hangar rod wasn't bent properly on the passenger side. I read reviews where some had the issue and others didn't. I just wanted to ask. Thanks for the reply and nice truck🤘🤘

[@joctancarmona2963]

thats a blackwidow with the 6 inch lift?

[@quickiereviews1428]

Totally is :)

[@johnwilkes8234]

What are the horsepower numbers

[@quickiereviews1428]

Honestly don't know the answer to that. I didn't dyno before & after, so no idea, but I doubt it's much. It's more for the sound for me & the look.

[@DavidHernandez-hc6xm]

Mpg increase?

[@quickiereviews1428]

Not sure!

[@michaelschiffel]

Could hardly hear the difference. You gotta rev it up a lot higher.

[@quickiereviews1428]

Yeah - truck wasn't warm at all when I took that vid (right after install), and I never took another vid. The only other vid I have is slowly going up the icy driveway here: kzbin.info/www/bejne/iaG5fqOqrrRjns0