1972 Chevelle Restoration: part 4

[@316JorMar]

working on 72 also really helpful tips thanks

[@bmxbobby1]

Damn good job

[@Zoniebaer]

Man where were you a few years ago! :) I have ben struggling with the body. and jump over to the mechanical. I have to back to the body.

[@rayhurd3554]

Thanks for sharing. I got to do the same thing to my car. Unfortunately the person I got the car from cut the whole trunk without any bracing

[@CottamCustoms]

That pretty much what happened with this one. You’re going to have to make it go where you want it to.😂

[@Plymouthgoat]

Where the front of the quarter panel meets the rocker, did you weld that or does that just get seam sealed?

[@CottamCustoms]

Depends on what you want to do. From the factory they are seam sealed, and people usually re seam seal it. We haven’t decided what we are doing yet😂

[@overdrive39]

why is the door dropping when you open it? get the door right before aligning the rest.

[@rayhurd3554]

What do you think about 3m panel bonding instead of welding

[@CottamCustoms]

I love 3ms 8115 panel bond. I usually use it to glue on bedsides. I’m not sure if I would do it instead of welding, but it has its time and place. For example, if you were doing a patch that went through the flat part of a panel, I would panel bond it on, just to avoid warpage.

[@bad_boosted_platinum7515]

What would a job like this cost labor wise?

[@CottamCustoms]

You are looking at around 6-9k to replace all of the sheet metal and get it in epoxy.

[@bad_boosted_platinum7515]

Sounds about right