1984 kawasaki kdx 200 bottom end rebuild part# 2

installing crank and gear shift kdx 200

[@MDavis91]

Bring er back to life!

[@ozgisch]

Hi, I have a 85 KDX 200, my gear shifter is stripped and trying to do a quick fix if possible and also try to find one inexpensive, would you know of any other types gear shifters that would work. Could I just jb weld the inside of shifter and put it back on. Plus would that be an easy fix when I do get the proper shifter. I found some on amazon but I'd have to bend the peg out a bit. Thanks in advance.

[@landereversull4464]

Can you show what under the air filter looks like I want to so if I’m missing any parts

[@stucklikechucklookinlikewh9501]

Great video! I have a 1998 KDX 200. The transmission was low on fluid when it locked up . The transmission is is only shifting into 1st, Neutral, & 2nd . I bought the Tusk crank puller and case splitter. This is going to be a great guide. Any idea why it won’t shift past 2nd gear?

[@AdamzGarage]

Great.. hope the video helps with your project. I'm thinking something cut loose and is getting lodged. Probably one of the shift forks 👍

[@freddieshannon8397]

Hi, my 1998 cr125 started leaking gear oil out of the bottom end, since it is an older bike, I figured it was a gasket issue because I know that the previous owner had never changed them, but if it could be something different please let me know

[@AdamzGarage]

Hi. Probably a gasket or seal like you said. Best thing to do is clean the motor the best you can, then run it and see if you can narrow it down. Could be case gasket, shift shaft seal ect... also look for hairline cracks in cases. Good luck with your project.

[@freddieshannon8397]

@@AdamzGarage Thanks, I plan on using you cr125 rebuild videos to help guide me through it

[@yonathancontreras6814]

By any chance do you still have Suzuki lt230e I been trying to find parts for it like a arm tie rods and more but I cant find

[@AdamzGarage]

Yeah, I still have mine. Did you try ebay at all. I've had pretty good luck most of the time.

[@yonathancontreras6814]

@@AdamzGarage don't mean to flood you with questions and request but by any chance you have a video on changing tierods and a arms if possible

[@AdamzGarage]

@@yonathancontreras6814 no problem at all. Unfortunately I don't have a video on the tie rods, but there not to hard to do. I do have a video on removing the A-arm bushings I'll leave a link. Not sure it's what you need buy hopefully it helps. kzbin.info/www/bejne/jn7afa1ro8SBbNk

[@reggie4524]

question is the transmission not supposed to turn a full 360 ?

[@AdamzGarage]

The transmission will turn a full 360, sometimes when it's apart on the bench its hard to get it to rotate fully by hand .

[@reggie4524]

@@AdamzGarage ok thank you