1991 - 6hp Johnson -Won’t Start …Let’s Fix it!

DVA Adapter
www.amazon.com/Electronic-Spe...
Part 1: Lower Unit Pressure Test Fails, Water Intrusion
• Water in Gear Case - P...
Part 2: Bad Lower Unit Drive Shaft Seals
• Water in Gear-case - B...
Part 3: Engine Surges and Stalls Fixed after the Lower Unit is Re-Sealed.
• Water in Gear-case - R...

[@evanodriscoll930]

awesome video

[@LivetofishOutboardRepair]

Thanks for watching

[@evanodriscoll930]

Would be awesome if you would have links to all the tools you use in the video in the description for us newbies

[@LivetofishOutboardRepair]

I used basic hand tools, Multimeter w/DVA adapter purchased at Amazon www.amazon.com/Electronic-Specialties-640-DVA-Adapter/dp/B0093U3TFG/ref=mp_s_a_1_5?crid=3QAIF4ZL20NLM&keywords=dva+adapter+for+meter&qid=1696590403&sprefix=DVA+adapter%2Caps%2C150&sr=8-5

[@evanodriscoll930]

Where do you find those voltage specs you are referencing in the video for a specific motor?@@LivetofishOutboardRepair

[@LivetofishOutboardRepair]

Google. Try www.CDIelectronics.com

[@LivetofishOutboardRepair]

@@evanodriscoll930 go to www.CDIelectronics.com click on the technical support tab then click on the technical support documents then DVA charts to find your specs for your motor.

[@patricklions9066]

Hello, how do I contact you about getting some work done? Need lower unit seals on 1971 Chrysler 45hp 457hc. I could ship the lower unit to you and pay how ever you like. Thank you, Daniel

[@Terry-dm3pz]

We have the same 91 6 HP and it doesn't start well.any sudgestions

[@LivetofishOutboardRepair]

Start by checking Compression and spark. If these are good then check your fuel delivery, fuel lines, primer bulb, fuel pump etc. If all is well clean the carb.

[@jonmetty]

@@LivetofishOutboardRepair what should the compression be? the cylmer manual just says that the two cylinders should be close to each other but doesnt give a PSI value

[@LivetofishOutboardRepair]

@jonmetty ... Some 2 stroke motors can run with as little as 70 psi Compression but should have at least 100 psi not have more than 10% variance between the highest and lowest Cylinder to be considered healthy motors.

[@Terry-dm3pz]

@@LivetofishOutboardRepair thank you Are they a dependable engine

[@LivetofishOutboardRepair]

@@Terry-dm3pz Yes very good motors if maintained.