Thanks, I have a bit of a roaring noise that is really noticeable with the back seats down. Hoping it isn't the pinion bearing, I'll try this first.
@jnamemoption77423 ай бұрын
Word to the wise; tighten the pinion shaft lock bolt before loosening it. That bolt tends to break upon removal. By tightening the bolt slightly any bond between the bolt, carrier, and pinion shaft will be reduced and then the bolt will be less likely to snap off into two pieces. Unless broken bolt screw extractions are your thing then this little pro tip may save time and money..
@doc5081 Жыл бұрын
Good stuff. You think the wheel spacers caused undue stress on that bearing? Im considering pushing mine out an 1". Thanks, stay well
@dillian66695 ай бұрын
Heey little question, i need wheel bearings I had two options to buy the bearing you show in the video but i could also buy taper bearings. Are your bearing the only type fitted? I have a an 98 ZJ dana 35. Wich looked like the ones i need.
@zbyneksurovec2 ай бұрын
What rear-end is this? Dana 35?
@johna.copelandiv8339 Жыл бұрын
I wish to replace my rear pinion in my differential
@kyledonahue337 ай бұрын
when you put the diff on dont you get a bunch of silicone in there? and do the bearings not need to get packed with grease?
@murraysullivan53686 ай бұрын
The bearing is lubricated from differential fluid down the axle tube
@tjsmountaingarage16136 ай бұрын
The silicone will squeeze out the side a little but not enough that it will get mixed with the gear oil. Just lay on enough to get a good seal and that's all
@patrickm-bmx9093 Жыл бұрын
Shouldn't the bearing get packed with grease?
@murraysullivan53686 ай бұрын
The bearing is lubricated from differential fluid down the axle tube.
@user-du3ml4pm6j Жыл бұрын
How many inch mentioned in the 5:8 min??
@tjsmountaingarage1613 Жыл бұрын
12 point, 1/4" closed end wrench
@randywall9230 Жыл бұрын
Please don't hammer with your hands, your carpal tunnel says that is what hammers are for - otherwise great video good info